Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Stacked Dado set

Posts

Stacked Dado set

#1

Stacked Dado set

Victor P

Hi all, I usually post of the quiet side, but I'm making a Q&D tool tray out of pine with plywood bottom for work and have decided to use box joints. Problem is my stacked dado set (Freud) is burning the pine. The sides of the cut look good but the bottom of the cut is black with carbon. Would the build up of resin on the cutters over the years be responsible for this or is it just a case of getting the cutters resharpened.

Thanks in advance

Victor

Re: Stacked Dado set

#2

JL

Re: Stacked Dado set

JL

If you have that much resin, you should be able to see it behind each tooth. I don't know about your dado set, but mine has about a 30 degree angle (or 60 degree depending on how you look at it) from the face of the tooth to the back. If you have that much resin accumulation, you should see it.

If you have resin, you can clean it off and test relatively quickly.

The other question is - has your dado set ever been sharpened? How old is it? Do you have some blades that haven't been used that much to use as a comparison? I know that I've never used some of the middle blades in my dado set. If the tops of the teeth are getting "squared off", you should be able to see it.

Re: Stacked Dado set

#3

Re: Stacked Dado set

Victor P

Looks like I'll try the oven cleaner first... I can see the resin build up but I don't see how it would affect the cutting. No, I've never sharpened these cutters, they look plenty sharp still maybe 8-10 years old and used occasionally (once or twice a year at most).

Good point about another blade that may never have been used, I'll check the rest of the box.

Victor

Re: Stacked Dado set

#4

Re: Stacked Dado set

Carol Reed

Don't use oven cleaner. Not the best product for the job. Toxic. Requires skin, eye, an respiratory protection, and it is a hazardous waste problem. It is also not good for the binder in the carbide teeth of your blades.

Simple Green works, as do any of the blade and bit cleaners on the market. Be good to yourself. Don't use the toxic stuff.

Get a fingernail cleaning brush. Let the blades soak for a bit and the brush will make quick work of dislodging the gunk. Rinse with clear water, dry (I use compressed air), and you are good to go.

Re: Stacked Dado set

#5

JL

As Carol said, Simple Green..

JL

Also, I use a brass brush - it holds up better than an old toothbrush.

Re: Stacked Dado set

#6

Re: Stacked Dado set

FredD

Dado sets for fingers joints are only way to make them.

You can use a jig with your TS blade or even better if you have a router table you will get flat bottom cuts , that are not possible with a Dado set.

Just a thought,

FredD

Re: Stacked Dado set

#7

Re: Stacked Dado set

Victor P

Thanks all.

I cleaned them up with Simple Green and a brass brush. First cut was slow and I burned the bottom of the joint again. The burns all went away when I started pushing the wood through quicker.

An interesting side note, when setting this up on Sunday evening I felt the joints were a little to tight for assemble with glue, so I used a .004 spacer between the chipper and outer blade and the fit was excellent. On Monday evening when I reset everything again the .004 spacer made the joint too loose. So I removed it and got a satisfactory fit.

Tonight I'll put some glue in the joints and see if it still goes together properly.

Regards from Houston

Victor