Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Just curious - vanity "floor" question

Posts

Just curious - vanity "floor" question

#1

Just curious - vanity "floor" question

Terry Alexander

Why is the face frame on a bathroom or kitchen vanity supposed to be "up" 1/8"?

Sure makes it a pain when building them....but just curious as to why it isn't dead even with the bottom/floor of the vanity.

As always....TIA

Terry Alexander in West Texas

Re: Just curious - vanity "floor" question

#2

Ellis Walentine

Not sure what you mean

Ellis Walentine

I don't know of any rules that say face frames should not be flush with the bottom of the cabinet. I never built them that way. Maybe cheap cabinet companies do it so they don't have to worry about being too accurate with their sizing.

Where did you get the idea that there should be an offset? Am I reading you right?

Ellis

Re: Just curious - vanity "floor" question

#3

I don't understand the question

Bill Tindall

"up" from what?

Re: Just curious - vanity "floor" question

#4

Re: Just curious - vanity "floor" question

Barry Irby

I don't think there is any reason for it. Actually, I can think of several. It makes the vanity hold water so you have a chance to catch a leak before it runs out into the floor. (Not a very good reason.) It makes it easy for the owner to install a piece of vinyl flooring in the bottom of the cabinet without interfering with the door. It is easier to install the frames consistently if there is a little "margin for error". The bottom might be rabbetted into the front? And.....

But the answer is, if you are building your own, and you don't want the lip there, do it your own way.

Re: Just curious - vanity "floor" question

#5

Re: Just curious - vanity "floor" question

FredD

Terry ,

When I make a vanity or a Kitchen bottom cabinet , I notch the end panels for a toe kick and have the notch extend down past the vanity bottom a half inch.

This gives you a bottom rail for the face frame a 1 1/4" in width assuming your using 3/4" plywood for the bottom.

Having a wider rail then the Vanity bottom is thick gives you a detail and a remaining surface that shows , even with overlap doors.

There is no reason to extend the bottom rail "up a 1/8th " that I am aware of and I have made a few cabinets .

FredD

FredD

Re: Just curious - vanity "floor" question

#6

Re: Just curious - vanity "floor" question

ash Sioux Falls, SD

Mine are flush . . . plus they have high pressure laminate on the bottom interiors.

Re: Just curious - vanity "floor" question

#7

Re: Just curious - vanity "floor" question

Kirk (KC) Constable

I've always thought it was to provides a little stop to keep things from sliding out as easily when you reach under there for the Comet... but when I build a cabinet like that or a display cabinet that might hang on a wall, I'll do it like that so I don't have to worry about making the 'joint' look good.