Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Delta # 11-990 12" Drill Press

Posts

Delta # 11-990 12" Drill Press

#1

Delta # 11-990 12" Drill Press

George Colonel's Workshop-Havertown PA

Good Afternoon Friends,

Perhaps 4 years ago I bought a used Delta Drill Press from a friend. It was in good shape, worked well when I tested it, and had no rust. I gave it to #1 son. He has given it moderate use until he noticed run out. I removed the spindle assembly and chuck. Called Delta and they indicated the problem was probably the spindle, which they had for sale for less than $20. I was reluctant to buy the spindle since I didn't know it actually was defective, and Delta and I each agreed the problem could stem from worn bearings and a bad chuck. The Delta tech rep still guessed it was a bad spindle. However, I elected to take the parts to the Porter Cable Service Center in South Philadelphia and let them tell me which component needed replacing. I waited two weeks. They told me I needed to replace all parts at a cost of $90.00.

Of course I don't know for sure, but my instincts are that all they did was to price the cost of all parts and add in their labor. Maybe I have a suspicious mind.

I think maybe I should order a new spindle from Delta, and install new bearings from Delta or Grainger. Not sure what to do about the chuck. My guess is that I can do it all for a lot less than $90. Comments?

George

Re: Delta # 11-990 12" Drill Press

#2

Re: Delta # 11-990 12" Drill Press

gcozad

I have restored a handful of vintage drill presses. Many times over, unless the DP was severely abused, the bushings are the culprit of run out. Chucks can wear out and bring about the same issue. But for na extra $20 for the spindle, I'd replace it simply for knowing the fact that it has been upgraded.

Re: Delta # 11-990 12" Drill Press

#3

Sounds Like

Mark Mandell - Gone Round In Jersey

"Soak the geezer from Havertown."

Why do so many service people believe that Seniors get stupid as they get older?

One thing you've learned here, George, is that the PC Service Center is a place to avoid.

BTW you can check part of your DP spindle and chuck on your lathe. DP spindles in this size are, I think, No.2 Morse. If so, clean it and the female on your headstock, insert, and check for the run-out yourself.

As mentioned, my bet's on the bushings