Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Staining Damaged Hardwood flooring (OT?)

Posts

Staining Damaged Hardwood flooring (OT?)

#1

Staining Damaged Hardwood flooring (OT?)

Barry Irby

At least the question has something to do with wood, if not furniture.

I bought a house that has Oak flooring. There was a water leak and there is a giant blob of darkly stained floor. Approximately four feet by ten feet.

They stained over it with sort of gunstock brown stain, but it is still visible. I'm wondering if there is something better to do. I know I could remove the flooring and replace it, but I don't think this house qualifies for that much work.

My experience is that these stains, including pet stains won't bleach out. Is it possible to bleach the whole floor to oblivion and then stain it back to look like wood?

Could I do something like sand the floor, stain around the blob, seal the whole floor and then glaze or stain over the seal coat to even it out more. I know I could paint it, but I wanted the grain to show a little. Any ideas?

Re: Staining Damaged Hardwood flooring (OT?)

#2

Re: Staining Damaged Hardwood flooring (OT?)

Joseph Mulherin, Sr

Barry, I googled "ridding oak floors of ater stains" and came up with a couple answers for you. They said you might try "oxalic acid". Mix up a batch and spread it over the stain and it will take out the entire color of the wood too. And you will probably have to do some of the rest of the room to get it to match.

Another suggestion was to call WES Distributers at 519-582-2621 and ask for Tim or George and they will have an answer for you. Hope this helps....

Re: Staining Damaged Hardwood flooring (OT?)

#3

JL

Re: Staining Damaged Hardwood flooring (OT?)

JL

If it is a metal based stain (iron or whatever), the oxalic acid will help chelate the responsible metal and reverse some of the staining.

If it is a pet stain or an organic stain, the two part wood bleaches have worked for me.

Re: Staining Damaged Hardwood flooring (OT?)

#4

Re: Staining Damaged Hardwood flooring (OT?)

Jorge Casta�eda

Barry

I had good luck sometimes removing the black water stains in oak using oxalic acid.

Re: Staining Damaged Hardwood flooring (OT?)

#5

Clint Searl

An 8 x 10 oriental rug is the way to go

Clint Searl

Re: Staining Damaged Hardwood flooring (OT?)

#6

Or...a Persian Polar Bear rug  *LINK*

Tom Dunlap


Persian Polar Bear rug

Re: Staining Damaged Hardwood flooring (OT?)

#7

JL

Love it!

JL

Re: Staining Damaged Hardwood flooring (OT?)

#8

Re: Staining Damaged Hardwood flooring (OT?)

Al Stokka - Cambridge, Iowa

Barry,

I've used oxalic acid on walnut. Had a table on which houseplants were displayed and water overflowed the pots, seeping under the pots unseen. The result was black (imagine what a black magic marker circle would look like on walnut) rings. Below are the steps I followed with great success:

1. Wood must be free of all coatings, waxes and oils. Use stripper, wood cleaners, sanding or scraping to remove coatings, waxes and oils.

2. Wear rubber gloves, protective clothing and eye protection when using this product. (I do wear eyeglasses, but skipped the rubber gloves demanded on the product label. ;^))

3. Dissolve 12 ounces of oxalic acid (powder) 1 gallon of HOT water. Stir thoroughly until all crystals are completely dissolved.

4. Apply the HOT solution with a scrub brush, green Scotchbrite or old tooothbrush. (I used the Scotchbrite.) On larger jobs use a mop. Apply liberally allowing the solution to remain on the surface until it is bleached to the desired lightness. If the solution cools before the job is finished, reheat but do not allow the solution to boil. Be patient, the acid solution takes a bit of time to remove the stain and may take 2 or 3 applications.

5. Rinse the bleached surface repeatedly with clean water and allow it to dry. I think for the large floor area you have I'd mop it with plain water, dry with a shop vac, repeat, rather than wait for the water to dry by evaporation. Test the removal of bleach from the dried wood by wiping it with a dark colored cloth. Check for powder residue. If powder persists, rinse the surface again with clean water and allow to dry.

6. Sand wood and finish with desired product.

Although product hype says otherwise, I found that the acid mix DID raise the grain slightly. A bit of sanding with fine sandpaper took care of that.

The walnut table was finished with Watco oil and paste wax so that made finish removal easy. Your floor finish will likely be more work to remove. The black marks on this walnut table dissappeared completely, as in, I can no longer tell where they were. I wish I had taken pictures. I think you'll like the results on your floor.

I found the oxalic acid (cheap) at The Chemistry Store (www.thechemistrystore.com).

Al

Re: Staining Damaged Hardwood flooring (OT?)

#9

Re: Staining Damaged Hardwood flooring (OT?)

Barry Irby

Al, I had heard the Oxalic Acid would bleach the wood WHITE. Are you saying it took it back to the walnut color, removing the stain but not bleaching the wood itself?

That would be great.

Re: Staining Damaged Hardwood flooring (OT?)

#10

Oxalic acid can sneak up

Gary Smyth

Oxalic Acid is used for a lot of things, but be careful still. I still have burns on my wrist from a relatively weak solution I used for rust what I believed to be a "safe", "fireproof" cabinet that also some paint cans. Four months later four of the cans had burst in the cabinet, apparently a little at a time, as there was no tell tale puddle until I opened the cabinet. That acid will sneak up on you.

Re: Staining Damaged Hardwood flooring (OT?)

#11

Re: Oxalic acid on walnut

Al Stokka - Cambridge, Iowa

Barry,

Yes, the oxalic acid mixture removed the black stain and left the walnut looking like...walnut.

There was a black ring about 2" in diameter on the table. After the acid bath and application of a few (3, maybe) coats of watco oil I can not see where the ring was. After the acid but before the Watco it seemed that I could see the treated area, but I think that appearance was more due to the Watco haveing been removed than to bleavhing of the wood's color.

I, too, have heard stories of oxalic acid removing the wood color. I don't know where those stories come from, but de-colored wood is not my experience.

Al

Re: Staining Damaged Hardwood flooring (OT?)

#12

Thanks.

Barry Irby