Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Disassembly of cured yellow glue joints

Posts

Disassembly of cured yellow glue joints

#1

Disassembly of cured yellow glue joints

Bill Tindall

At our last club meeting Buddy Floyd, furniture restorer and master cabinet maker, described furniture repair and restoration. Among the many tips was one on how to disassemble joints. The myth goes that one should not use yellow glue in furniture as it can not be disassembled like hide glue. Not true.

To disassemble a yellow glue mortise and tenon joint it is first drilled most of the way through, about in its center. For a source of steam I used a pressure cooker, a short length of hose and a basket ball inflation needed, as recommended by Buddy. The needle is stuck loosely into the hole and steam applied. After about 6 min I tapped the joint with a mallet and it came apart cleanly. Frankly, I was astonished at how easily it worked.

Re: Disassembly of cured yellow glue joints

#2

Re: Disassembly of cured yellow glue joints

john lucas

I've heated the wood before and been able to break a joint open but I love the basketball inflater idea. That's brilliant.

Re: Disassembly of cured yellow glue joints

#3

Seems like that thing could become a weapon!

Charles Yawn

Re: Disassembly of cured yellow glue joints

#4

Re: Disassembly of cured yellow glue joints

Chris Friesen

Have you tried this on the more water resistant glues like TBII or TBIII?

Also, from what I understand you'll need to get the glue off all the surfaces of the joint, then either glue it back up with a gap-filling adhesive or else glue on some veneer to fatten up the tenon before using PVA again. Is that about right?

Re: Disassembly of cured yellow glue joints

#5

no, yes

Bill Tindall

I don't know what anyone uses Titebond II or III unless they are doing outdoor work. I expect many buy the stuff because they think it is better. I have not tested it.

Agreed to second part.

Re: Disassembly of cured yellow glue joints

#6

reasons to use TBIII

Chris Friesen

I use TBIII because of two reasons, the longer open time and the low chalk temperature which is convenient during the long cold prairie winters. This saves me money on the shop heating bill and means I don't have to wait as long for the material and glue to warm up to gluing temperature.

Re: Disassembly of cured yellow glue joints

#7

Yikes!

Bill Tindall

Those are certainly valid reasons.

It makes me shiver to think about working in a shop that cold. You folks up there are just sturdier.

Re: Disassembly of cured yellow glue joints

#8

Re: Yikes!

Kneale Brownson..Back enjoying CO snow

Thicker Blood

Re: Disassembly of cured yellow glue joints

#9

Typical guitar repair trick

Groucho

Luthiers who need to disassemble a neck from a guitar body first remove the 12th (or 14th) fret wire (whichever is directly over the neck/body joint), drill a tiny hole or holes down through the fret groove into the joint, insert the steam needle and wait for the glue to soften. Classic trick.

Groucho

Re: Disassembly of cured yellow glue joints

#10

Re: Disassembly of cured yellow glue joints

Keith Newton----Little Rock, Arkansas

Bill that is a great tip. I would imagine that it would work for epoxy also. Epoxy will soften somewhere ~ 200�, but the moisture would not help like standard yellow glue.

As for gluing up a sloppy M&T. thickened epoxy is my choice over veneer shims.