Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Tablesaw blade height observation

Posts

Tablesaw blade height observation

#1

Tablesaw blade height observation

Dave Paine

I am not trying to rehash the January thread on blade height, but today I got to make my own observation.

After the January thread I decided to try lowering the blade so that it was a little higher than a tooth.

Today I needed to true up a 10 in piece of 7/8 in think oak. I was taking off about 1/16 of material.

The saw was having a tough time, and the cut showed burn marks.

I raised the blade to my previous height, made a cut of the same 1/16 of material to be removed. Motor was not having any problems and the cut was the normal smooth finish with no burn marks.

The blade is Ridge Carbide, which is meant to have more side clearance than my Forrest WWII blade.

This si not intended to be a conclusion, just one data point.

Re: Tablesaw blade height observation

#2

Re: Tablesaw blade height observation

Bob Entwisle in NJ

Hi Dave,

Yes, I have made similar observations.

I think that like everything else woodworking, one needs to understand and be able to adjust for the specific conditions at hand.

While keeping as few teeth of the saw blade exposed as possible sounds like, and 'probably' is a good general rule, there are other forces at work which need to be taken into account in order to accomplish the task at hand. If keeping the blade low causes the saw to bog and the wood to burn, then something is wrong and adjustments need to be made.

Re: Tablesaw blade height observation

#3

Re: Table Saw blade height observation

Barry Irby

Dave, I'm guessing here but I would bet the problem is that you were making and "unbalanced" cut. By making a cut that was less than the thickness of the blade the blade was trying to turn out of the cut toward the free air. So the teeth were pushing the blades out of the wood and the strength of the steel was pushing it back, causing it to rub on the fresh cut and burn.

If the blade is making a full cut there are no unbalanced left/right forces and the steel keeps it cutting straight. Obviously, sometimes the grain tries to lead the blade one way or the other and that would cause burning, but in a balanced straight cut the blade would work as intended.

As an experiment, sneak up on the cut. Make a cut where you remove less than half the width/thickness of the blade, half, more than half, full thickness and slightly more than full thickness and see what happens?

Hmm, It might not be good for blades to remove very small amounts and I do it regularly.

Re: Tablesaw blade height observation

#4

Re: Tablesaw blade height observation

Bill Howatt

Could be that your blade height adjustment is not running true and when the blade is down it is not parallel to the miter slot but is better when full up. Would need some careful measurement.

I, and also not wishing to rehash blade height arguments, always cut with the blade high and with my overarm guard. I think there is less blade buried in the wood with this orientation which may result in less "binding".

Bill