Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Planer Question (Taper?)

Posts

Planer Question (Taper?)

#1

Planer Question (Taper?)

Bob S

Can a planer (bench mount, or industrial version), be used to plane a TAPER onto a board, across the board. I need to make a 6" wide board have a sligth taper to it and am wondering if I could make a jig to hold this and run it through a planer. I have access to several very good planers but am not sure if the guy (teacher), will allow it, and can't as until next week.

Thanks,

Bob

Re: Planer Question (Taper?)

#2

Re: Planer Question (Taper?)

mike American Sycamore

yes it will work very well. Just build a good solid base and no short pieces and you should have no trouble at all. Good luck

We even have done small pieces by building a sled at a taper and using double stick tape and gluing down stop pieces to keep the stock in place.

Mike

Re: Planer Question (Taper?)

#3

JL

Re: Planer Question (Taper?)

JL

I have two taper sleds that I've built out of plywood. I typically use them to tape legs. One has a 3 degree slope to it. Anyway, I've got a lip on the lower side. I typically hold the legs to the sled by butting them up to the lip and holding them down with double sided carpet tape (on the sled side of the legs). The sled supports most of the legs.

I feed the sled through the planer multiple times and then rotate the legs and feed again. Works quite well. It is slower than cutting the legs on a table saw - but it does work well.