Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Inca 570 Jointer Planer Question

Posts

Inca 570 Jointer Planer Question

#1

Inca 570 Jointer Planer Question

Hank Knight

My Friend Kelly Springs from over on WoodNet has recently bought a used Inca 570 jointer planer that looks to be on good shape. He has run into a problem in the planer mode. The checkered feed roller appears to be out of adjustment. It presses so hard that the stock stalls before the knives can begin the cut and it leaves the chekered indentations pressed into the surface of the stock. Is there an adjustment for this - surely there is. I have a 570, but I've never had to adjust the feed roller. Plus, I'm at work so I don't have access to my machine or my manuals (which are only marginally helpful at best). I've given Kelly Jesse Berrigan's name and phone number at Eagle Tools, but I thought someone here might have an answer.

Thanks.

Hank

Re: Inca 570 Jointer Planer Question

#2

Ellis Walentine

Re: Inca 570 Jointer Planer Question

Ellis Walentine

It sounds like he's trying to take too big a bite in one pass.

Ellis

Re: Inca 570 Jointer Planer Question

#3

Re: Inca 570 Jointer Planer Question

Hank Knight

Ellis,

Kelly's machine wasn't cutting at all - the feed roller was keeping the stock too far away from the cutters. When he cranked the bed up to get it to cut, the feed would stall before the wood got the the blades.

I went home at lunch and looked at my owners manual. It looks like the brackets that hold the feed roller are spring loaded. I think we figured out that the brackets were stuck all the way in the down position - probably rusted a little - the machine has been sitting in a garage unused for several years. Kelly put some WD40 on them and got them loosend up some. Now it cuts, but it's still a little rough. He's going to get some penetrating oil and see if that frees them up better. It looks like we're on the right track. I don't want to have to disassemble the machine to get to the problem if we don't have to.

Hank