Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Slightly OT - What is this tool.

Posts

Slightly OT - What is this tool.

#1

Slightly OT - What is this tool.

Pat Riley

>No one in my family knows what this tool might be. It was stored with other items - lid lifters etc. - that were kept with my Great Grandmothers wood fired cooking stove. It may just be a cooking utensil. I think it may be something that went alone with operating the stove.

I told my mother that one of my good friends here at Wood Central would know exactly what it is.

Sorry about the poor quality picture, it was a quick one off my phone.Any help would be greatly appreciated.

Pat


Re: Slightly OT - What is this tool.

#2

Re: Slightly OT - What is this tool.

Bill Earl

>I think it is a rug-beater. You hang the rug outside and whack it with that to beat the dirt & dust out.

Re: Slightly OT - What is this tool.

#3

Re: Slightly OT - What is this tool.

Mike Squire

>Can't tell about the size. If it's too small for the rug beater, it could be a trivet.

Re: Slightly OT - What is this tool.

#4

Heat control

Charles R. Smith

>My grandmother had one in her kitchen in Saskatchewan. I saw it used for heat control, since such stoves lack control knobs. It is for simmering -- you place it between the cooking surface and a pot to reduce the heat being delivered to that pot, while the other pots on the stove are getting full heat.

However, this recollection is from when I was five years of age, so my memory might have been clouded during the five-decade interval.

Charles (who loves the smell of a wood stove)

Re: Slightly OT - What is this tool.

#5

Dale Lenz

Sounds like a winner to me   

Dale Lenz

Re: Slightly OT - What is this tool.

#6

My first thought too . . .

steve mackay

>Used ON the stovetop to "lower" (kinda "indirect") the heat to a pan. I've cooked on a full size wood stove and that would have been handy.

Re: Slightly OT - What is this tool.

#7

Re: Slightly OT - What is this tool.

Marv

>Go over to the quite side, they think they have the correct answer...

Marv

Re: Slightly OT - What is this tool.

#8

I don't understand your answer

Gary Smyth

Re: Slightly OT - What is this tool.

#9

Re: I don't understand your answer

Barry Irby

The same question was posted on the Hand Tool forum. Look under Messageboards at the upper left.

The Hand Tool forum gets called the Quiet Side or sometimes the Neanders (neanderthals).

The general Message board are the electron burners, noisy side, tailed tools, Normites (from Norm Abram who does most everything with power tools)

The Turning Forum is the Round side among other things. They call the Message board the Flat Side.