Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Semi-OT MDF Crown Movement

Posts

Semi-OT MDF Crown Movement

#1

Semi-OT MDF Crown Movement

Ken Bellock (Houston, TX)

>I was always under the impression that MDF was very stable, when dry, and that movement was negligible. We have a new house that was built a little over a year ago in Houston, TX, in which they installed crown in two rooms that was made from what looks like MDF. When I turn on the heat, in less than 5-10 minutes, I can hear the corners popping apart, and the gap in the miters opens up by as much as 1/16". The one room is an office and is very small, so the runs of molding are no more than 11'. Is it the change in temperature that is causing this, or dry air from the heater. I know if it was real wood it would be completely related to the humidity levels of the air and not the temperature at all, but since it happens so quickly I wonder if MDF, as an engineered product, does move with differences in temperature, or if it just moves quicker than real wood with moisture changes.

These houses were slapped together as quick as possible with caulk as a structural component, by guys who might have picked up a hammer for the first time in their lives that morning, so of course the inside corners that are popping are mitered, not coped.

I guess the followup question would be what is the best way to patch a crack that can move by as much as 1/16" in 10 minutes every time the heat comes on...

Re: Semi-OT MDF Crown Movement

#2

Re: Semi-OT MDF Crown Movement

Jim Shaver

>Hey Ken,

I would also consider seasonal swings in humidity that effect the house itself as part of the problem. In my home the roof trusses move with the drier winters, they cause some movement in the ceilings and walls, minor, but they still move. I had the same issue happen with mdf crown in my home, the gaps appearing in the winter. An application of chalking and paint and it looked like new, no problems this winter.. remember chalking is your friend! ;)

Take care,

Jim

Re: Semi-OT MDF Crown Movement

#3

Re: Semi-OT MDF Crown Movement

Alan in Little Washington (NC)

>I have MDF crown throughout my house, and though I experienced some shrinkage, mainly the first year, it has been nothing like you describe. The painter came back and puttied all gaps. Only a few, very narrow ones have returned five years later.

Is it possible you have vinyl, plastic, or some other material crown? Vinyl changes dimension much more than than MDF and it is affected by both temperature and humidity.

Re: Semi-OT MDF Crown Movement

#4

Re: Semi-OT MDF Crown Movement

FredD

>Rather then caulk the gap in the miter when it appears, cut some wedges from 4/4 hardwood, like Oak.

Make the taper in a seven inch length about 3/8ths thick at one end to nothing at the other and depending on whether the gap is open at the or bottom , insert the wedge behind the Crown and bring it closed.

Score what remains of the wedge with your utility knife and snap it off flush

This should not need to be repeated , unlike caulking.

FredD

Re: Semi-OT MDF Crown Movement

#5

Re: Semi-OT MDF Crown Movement

Ken Bellock (Houston, TX)

>Fantastic! Makes perfect sense, thanks for the tip!