Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Formica Repair Question

Posts

Formica Repair Question

#1

Formica Repair Question

Jerry Draper

>About a year ago I made my daughter a computer desk with an inlaid formica top. A section of the formica has come unglued - 2 inch section near an edge. I cannot get enough access to reapply contact cement. Can anyone offer a solution for correcting the problem?

Re: Formica Repair Question

#2

Re: Formica Repair Question

Dave Bair, Eaton Rapids, MI

>Inject Titebond 3 and clamp it up.

Re: Formica Repair Question

#3

Re: Formica Repair Question

George Koch

>Jerry, I would try a steam iron over a damp cloth or lift the corner slightly and use spray contact cement. George

Re: Formica Repair Question

#4

Re: Formica Repair Question

Dick Coers

>I would try to inject some lacquer thinner to soften the contact cement, then clamp. Of course, you would have to be really careful around any finished wood!

Re: Formica Repair Question

#5

Re: Formica Repair Question

FredD

>If you want to lift a section of the Formica so you can get glue under it (Titebond like Dave says will work ) or Contact if you can get it on the underside of the plastic and on the substrate, I have found that the easiest way to release the glue without any damage to anything else is to get a can of lighter fluid and squirt a little under the plastic as you raise it.

It will release the glue bond nearly instantly and because it is Naphtha will flash off quickly.

I wouldn't recommend spraying contact glue unless that was all you had and you could completely mask off the surrounding area, contact glue where you don't want it is not easy to clean up.

FredD

Re: Formica Repair Question

#6

Thanks guys - i now have a plan.

Jerry Draper