Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

power feeder assistance please

Posts

power feeder assistance please

#1

Dave

power feeder assistance please

dave

>Hi,

I have an upcoming project that will require a vary large ## of feet of molding and am considering a power feeeder for the router table.

I have a old Boyce Crane shaper(small) that was converted to a router table (shaper part was rusted junk). it has a nice cast Iron top, about 20" deep x 24" wide.

I am thinking the 1/4 hp grizzley 3 wheel feeder. Is it large enough hp, rollers, is it a decent piece? other suggestions? Are they a really good thing to have? I do a lot of small moldings, will they do small stuff?

Thanks to all, Dave

Re: power feeder assistance please

#2

Re: power feeder assistance please

Thomas Norton

>Dave,

I have a Delta 1/4 hp with 3 wheels. It works great and I use it on my shaper and table saw. Just yesterday I set it up on the table saw because I had 23 drawers that needed to be grooved for the bottoms. So 4 x 23=92 parts. It really helps. As for small pieces as long as it can grab and stays clear of the cutter it should work. I replaced my rollers with new ones from Western Roller and what a difference. Also you end up with more consistent results.

Tom