Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Semi-OT - hardwood floor cupped due to moisture

Posts

Semi-OT - hardwood floor cupped due to moisture

#1

Semi-OT - hardwood floor cupped due to moisture

John E in SC

>I'll spare everyone my plumbing nightmare, but let me just say there was a leak in my shower that led to water getting under the maple hardwood floor I installed myself in my bedroom. For about 3 feet around the wall where the leak occured, the face of each board is pretty badly cupped. This leak was fixed about a week ago now, and so far, now change in the cupping. Can I expect that this will improve with time as the boards lose moisture and re-equilibrate? Is there any way to speed this process along? Or am I basically up the proverbial creek? Appreciate any advice.

Re: Semi-OT - hardwood floor cupped due to moisture

#2

Re: Semi-OT - hardwood floor cupped due to moistur

FredD

>I hope the warped floor boards are parallel to the wall where the damage is done, since the warp will not return to its original state of flat.

Since you installed the floor you should be able to remove the courses of boards out to where the cupping did not occur.

If the boards are end on into the wall then it's a whole other operation which never under the best circumstances will be the same appearing as it was before the leak.

FredD

Re: Semi-OT - hardwood floor cupped due to moisture

#3

Re: Semi-OT - hardwood floor cupped due to moistur

Barry Irby

>Fred may be right, but I would not be too sure they won't flatten out more. Don't be in too big a hurry to rip them out or sand them flat. I would give them a few more weeks or even months. Wait long enough to be sure. In the mean time you could put a little heat on them like a light bulb (Old style that actually puts out heat) or a heat lamp and warm the surface a few degrees.

Another advantage to waiting is you may get used to the appearance and decide it is not bad after all. :)

If you sand the floor while they are warped and they decide to flatten out, they will have the opposite warp. If they are cupped now they will have a hump in them later. If they are bulging now they will be cupped later. Water running under them probably wet the bottom side more than the top and they cupped, edges curled up. It could take several weeks for them to dry on the bottom side. If they were very tight and had no room to expand they may have crushed each other and when they thoroughly dry they may have gaps. Wait and watch.

Re: Semi-OT - hardwood floor cupped due to moisture

#4

Re: Semi-OT - hardwood floor cupped due to moistur

gary peterson

>My thought is the water is under the floor, thus the area under the flooring is wet. Nothing can be done till this moisture is taken care of.

How you approach a fix is, as they say, up to you. For a great job sounds like a rip out, install, sand and refinish the whole room. gary

Re: Semi-OT - hardwood floor cupped due to moisture

#5

Re: Semi-OT - hardwood floor cupped due to moistur

FredD

>Let me rephrase,

If the flooring reminds you of a pleated skirt , you will not live long enough to see it return to a flat appearance...

FredD

Re: Semi-OT - hardwood floor cupped due to moisture

#6

Re: Semi-OT - hardwood floor cupped due to moistur

Andy Halterman

>John,

Get a fan and put in on low and let it blow across the floor for a few weeks. This will get the moisture out of the wood. See where the floor is in 3-4 weeks and then decide if it needs to be yanked and replaced.

I see this stuff regularly and in about a third of the cases, the floor either returns to where it was or close to it. I just looked at a floor the second time (6 weeks later) after it swelled and cupped from a roof leak. We turned the heat up (unoccupied summer home) and it has come back about 95%.

You need to have patience and let the fan do it's thing for a few weeks or more. You should start to see some results after about a week.

Oh, and by the way, fix the plumbing problem too.

:D

Andy Halterman

Enjoying the snowy winter in Hendersonville, NC�