We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
>Last year someone had given me some 2-1/2'' thick tiger maple, walnut, and according to him tiger cherry all about 8 ' long and 9-11 '' wide, about 7 boards each.This was payment for some landscape work I had done for him and he came up about $75.00 short. He stated he had the wood in his shed for over
20 years with no water getting to it. QUESTION, I would like to build a kitchen table with some of the wood, do I need to bring it in the house and dry it before I glue it up? I just do not want it to shrink really bad. I have it all in my garage which is dry but unheated.
if it has been exposed to the outside air , regardless of the shelter of the barn , it probably has acclimated to around 15 percent MC.
Warm it up in your shop environment until you reach the ambient MC in there which ideally would be around 6 percent MC , my shop for instance is heated in the winter and cooled in the the Summer to a constant 70 degrees and Kiln dried wood I get from the sawmill will go down to around 5 1/2 to 6 percent MC.
I live in Kansas , Florida would have higher MC and Arizona lower , so would the wood without artificial climate control.
If your wood is much higher then 6 percent MC and the place the table will live is about 6 percent , the glue joints may fail and the wood will shrink accordingly.
So will the joints joining the table.
This is a place where a Moisture Meter is handy to have.