take a step back......
Bill Tindall
>I am a wood oriented sort of woodworker so this advice is colored by this fact. I believe that some tree that took 500 years to grow beautiful wood deserves to become some well made and attractive piece of furniture.
I sat next to someone at our last club meeting and they were complaining about what a poor wood cherry was to work. They had built a table for their daughter. The top warped severely and they complained that the wood had numerous knots. Further discussion revealed that they had acquired the lumber from a local saw mill. Clearly, it was not dry and who knows what grade they may have bought. Also, clearly, this person was reaching too far to build something he had not yet acquired the skills to build. The result was failure and frustration.
You have some wood on hand that you will likely never be able to replace. This fact should be the main concern in determining what to do next. This wood is not the place to learn to do woodworking, though you may be close to being ready to use it. Step 1 should be to determine what you want to build. Step 2 is to learn what kind of skills it will take to build it. Step 3 is to acquire those skills and then practice them to be proficient. A class or a mentor can carry you through step 3 quickly. If there is a woodworking club in your area join it, make friends, and learn from them. Next build something that uses these skills where you will make mistakes and learn from them. Then use the fir to make some heirloom furniture.
Panels are not glued into frame and panel doors. Frames are made sufficiently strong that the panel is not necessary for strength, though it offers rigidity. Stuff is made the way it's made because during the last several hundred years of making stuff it has been determined what lasts and what doesn't. Don't try to invent new ways of building stuff, at least not yet.
There are lots of reliable ways to make a frame and panel door that mainly depend on the tools you have available. Most are not hard to learn. You will have to learn enough to pick a way that will result in a lasting door. Fitting and hinging the door will be harder to learn and should be practiced first. Again, a class or mentor will save years of trying to learn by trial and error.