Chest of draws
Bob
>Hi its about 2 years since I saw some timber in the yard where I worked it was about to be taken to the demolition yard, it was covered in many years of paint and had many nails in it, probably about 8 inch X 8 inch and 12 foot long I think there were 4 pieces one of them may have been shorter, I made a quick offer for them as I could not risk missing an opportunity I thought they would be Kauri a timber native to New Zealand.
I had to get them out quickly so they were home that night and taking up a lot of space in the garage.
The problem was what to use them for, I browsed the net for a while until I saw Richard Jones had a picture of a draw unit that appealed to me.
I have wanted a new chest of draws in the bedroom, so it was down to drawing, deciding on size and what changes to what Richard had done.
I have a vacuum pump and wanted to use it so round fronted draws became essential.
I started to cut up the timber and whhoo its not Kauri its Totara another N Z native that is very redish but its all good so glue up some ends I wanted to avoid the nail holes so some of the sizes of the finished article were dictated to me, by avoiding the nails I wasted a lot of timber, the rusty nails leave some horrid stains in the wood, I am cutting into the 3rd big piece of timber and find there is very little clear timber as burr occurs frequently the last piece is the same so a re think has to happen and it is too good to waste.
I had hoped to show you the end result on this page but I am not sure I am able to upload the photos so the best way is to give you my blog address. http://perceptionpanels.blodspot
Thank you so much Richard Jones the finished product is so appealing I just enjoy looking at such the lines. Bob



