Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Shoe Brushes

Posts

Shoe Brushes

#1

Shoe Brushes

Gary Smyth

>This week I latched on to a box of really nice horsehair shoe brushes. They are at least seventy years old and seem to me to have almost twice the number of bristles I've seen lately in similar items. The problem is that the bristle bottoms are heavy with shoe polish. On a couple of the brushes several bristles have very small "BB" clumps. I need to remove the polish to allow the brush do its work. Polish is essentially wax but I do not want to dissolve the hair or have the bristles fly out to the side (as opposed to straight down) of the brush if I use detergent. Anyone have any ideas. Acetone or thinner combed through? Steam? Wire brush? What dissolves wax?

Looking for alternatives.

Re: Shoe Brushes

#2

Mineral spirits dissolve wax

Bill Houghton

>I would experiment a little, though, with the scruffiest of the brushes.

You might, once you get the wax softened up, be able to comb some of it out - a paint brush comb, available from your local pro's paint store, probably best for this.

Odorless mineral spirits are less ferocious than odorous - at the cost of taking longer, the milder odorless might be better.

Re: Shoe Brushes

#3

some ideas

Roy Anderson

>Here is a brain dump. Experiment around and see which one works best.

Soaking in hot water will loosen wax

Virtually any petroleum solvent will dissolve wax. Mineral spirits, naphtha, WD-40. Note: WD-40 does not contain fish oil or silicone as is sometimes rumored.

Warm vegetable oil, like canola oil or soybean oil, will dissolve wax.

Soaking in full strength household ammonia cleaner will dissolve wax

After you have it loosened, comb out with an old comb

Good luck and let us know which method works best.

Re: Shoe Brushes

#4

wax solvents and techniques

Bill Tindall

>Any hydrocarbon dissolves wax- mineral spirits, toluene(best), turpentine and the hydrocarbon will not affect the hair(think paint brushes). The wax will dissolve much better if the solvent is warm but of course this increases the flammability concerns.

However, I am not sure this is the way to proceed. The adhesive that holds the bristles in may dissolve, or the finish on the brush. Maybe if you just dipped the ends into warm solvent it would accomplish the task. I would first try getting the brush warm and see if I could rub/comb the excess wax out. The warming could be accomplished with a hair dryer.

Re: Shoe Brushes

#5

Re: wax solvents and techniques

Art Luczynski

>;) Warm (hot) soap and water should clean them just like washing your hair rinse all the soap rinse out with warm water and let them dry.

Re: Shoe Brushes

#6

Re: Shoe Brushes

FredD

>I think I would take a paper towel and lay it in the Microwave with the worst brush on it and set the Microwave on it's defrost cycle and see what happens..

The wax will surely melt and run down.

Combined with clean up with a solvent should leave the bristles intact.

You never know until you try ;-))

FredD

Re: Shoe Brushes

#7

Re: Shoe Brushes

Art Luczynski

>I learned this form an old shoeshine man in the 50tys when everyone shined shoes. Soap and warm (hot) water works I have white empire brushes that old and that is how I have cleaned them many times it works.

Art

Re: Shoe Brushes

#8

Jesper, Denmark

Re: Shoe Brushes

Jesper, Denmark

>Simple, Wash the brushes in hot water with a little detergent and let dry - good as new.

Standard Operating Procedure.

Re: Shoe Brushes

#9

Re: Shoe Brushes

Howard Acheson

>What do you intend to do with these brushes? How clean do they have to be?

Re: Shoe Brushes

#10

Re: Shoes.  But I'm particular.

Gary Smyth

>Just get them back to what they were intended to do

Re: Shoe Brushes

#11

Jesper, Denmark

Fire Hazard!!!!

Jesper, Denmark

>You might find that the microwave will set the brushes on fire - be careful.