Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Router Inlays

Posts

Router Inlays

#1

Router Inlays

Stephen Kirk

>Well, I picked up an inlay kit for the router. After adding a new baseplate to take the guide bushing I was off. Tried a simple circle with great results. Then I made myself a butterfly template and that also worked well. I was just trying it out and used some thin hardboard as the veneer and added it into some old plywood.

Only odd thing is that the inlay piece was too tight and needed quite a bit of sanding. Not sure what caused that. I did center the bit first.

All in all, this is a nice and simple technique.

Re: Router Inlays

#2

Re: Router Inlays

Tom Rex in TX

>Which one did you get & where did you get it?

Re: Router Inlays

#3

Re: Router Inlays

Stephen Kirk

>I picked up the Whiteside set from Woodcraft. Think it ran about $45.

Re: Router Inlays

#4

Re: Router Inlays

Neal in San Jose

>I have one also; don't remember the brand. One thing I have noticed is that all brands of 1/8 bits are not exactly the same size. That will make the inlay snugger or looser. Those little bits are fragile, so you will have an opportunity to try other brands of bits, DAMHIKT!

If you are ever in my shop and notice that I have two artfully placed contrasting butterfly inlays in my bench top, you'll see the first time I used my set. I had just finished routing something with a full-sized bit, and put the router down before it had spun down to a stop with the expected results - a gouge in the bench top. Just to make sure I had exercised all of the swear words I knew, I did it again about 10 minutes later! So it was off to one of the on-line retailers for the router inlay set, and a week or so later I was delighted by how well I had recovered from my mishap.

Re: Router Inlays

#5

Re: Router Inlays

FredD

>Not mishaps Neal , design features ;-))

FredD

Re: Router Inlays

#6

Re: Router Inlays

Stephen Kirk

>Haha, I have a few of them I never repaired. Hmm, now that I have the kit, perhaps I should take care of them.

I know those bits look pretty fragile. If I want to make some thicker inlays, I'll consider a couple of shallow passes to define the edges and make the inlays, then switch collars and bits to take out the waste.

I'll have to watch my pressure, too, and make sure I'm not going a little light around the edges.