Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Jet Dust Collector Motor bearing replacement

Posts

Jet Dust Collector Motor bearing replacement

#1

Jet Dust Collector Motor bearing replacement

Dave Paine

>I have a Jet DC-1100 which is likely out of the 5 year warranty. Anyone remember the last year Fort Washington had a Woodworking show? Likely when this was purchased.

The unit has a short chirping sound when the motor capacitor has disengaged after power down. I expect this is the beginning of a bearing failure.

I looked at the manual, and as expected, the motor is a spare part, but the bearings within the motor are not mentioned.

Anyone with any words of wisdom. Take entire motor to an electrical shop, or remove the bearings myself.

I have replaced the bearings of a 1/2 HP TEFC motor on the house fan. Took awhile to pull the old ones off the shaft. I expect if I can remove the bearins, I can find replacements locally.

I do not want the DC to be out of service for long, since only a shop vac as backup.

Re: Jet Dust Collector Motor bearing replacement

#2

Re: Jet Dust Collector Motor bearing replacement

Forrest Addy

>The chirp is probably the start witch collar snapping back in contact with the switch cam. If the motor run OK but squeaks or chirps at coast down about when the start switch re-engages, that's your answer: it's switch not bearngs.

Pull off the endbell (Carefully! There may be wires attached) and smear a little stiff grease on the collar face. Observe safety etc.

Re: Jet Dust Collector Motor bearing replacement

#3

Re: Jet Dust Collector Motor bearing replacement

Dave Paine

>Thank you for the reply. The chirp is definately as the motor disengages. I thought this was the capacitor, but it may be the magnetic switch.

I will take a look. A small application of grease is much easeier than a bearing replacement.

The unit does not have any unusual sounds while running. Fingers crossed it is the switch.