Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Water based finishing question

Posts

Water based finishing question

#1

Water based finishing question

doug f, san clemente, ca

>I'm adding some solid wood edging to a cabinet made of pre-finished plywood. The plywood is finished with several coats of water based Enduro Clear Acrylic.

Question is this; have any of you tried wiping this finish on? I sprayed the plywood and decided to add the edging after it was assembled so I'd like to avoid breaking out the sprayer and stuff to just do a few pieces of walnut edging.

Anyone have any experience with this stuff?

Thanks for the help.

Doug

Re: Water based finishing question

#2

Enduro

Mark Mandell - Gone Round In Jersey

>Use it all the time. Great stuff; came through the smoke and water damage in an apartment fire in Brooklyn unscathed.

If I get you correctly, you wish to use a solid wood edging on prefinished ply. My suggestion would be to tape off the prospective glue surfaces, hand-apply the Enduro to the edging, then strip the tape after 48 hours and carefully glue to your ply. If you're careful to wipe off any glue squeeze, you should be done at that point. As far as application goes, I suggest you use a fine nylon brush, wiping and sponge brushes will put too much air in the film, resulting in a rough surface and/or pits.

JMO, YMMV