Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Unisaw lubrication

Posts

Unisaw lubrication

#1

Unisaw lubrication

Paul Blackwell

>A few days ago I posted a request for info on the procedure for changing the arbor bearings on a Unisaw. I pulled it apart yesterday, and after removing the belts, I found that the arbor pulley was slightly loose on the shaft. I tightened the set screws, put the belts back on and the saw runs quietly with no growling sounds. My question is, is it proper to lubricate the tilt and raising mechanisms with something like dry graphite? What do you use? Any info greatly appreciated. Thanks to all for the sources for the bearing change links.

Re: Unisaw lubrication

#2

Delta technician recommendation

Bill Tindall

>I took a class on maintenance years ago and the instructor used Johnsons paste wax to lube the moving parts.

Re: Unisaw lubrication

#3

Re: Delta technician recommendation

Doug Reynolds

>Fine Woodworking had an entire article devoted to the subject of cleaning and lubrication of a cabinet saw. I don't have the issue number handy but, am sure a search would provide the issue number.

Re: Unisaw lubrication

#4

Re: Delta technician recommendation

Fred Davis

>Delta is currently reccomending Dry Graphite or a light coating oc Lithuim grease.

I have used White Lithuim for a lot of different things like coating the plastic threads on a whole house water filter , so one could get it off to change the filter.

FredD

Re: Unisaw lubrication

#5

Re: Unisaw lubrication

Brent Smith in Montreal

>I use spray graphite.