Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Bandsaw problem

Posts

Bandsaw problem

#1

Bandsaw problem

Kevin MacLuskie

>I've got a Jet 18" Bandsaw running a 1 1/4" timberwolf 3-4 blade for resawing. I ran several boards though, about 90 linear feet worth with no problems at all. Then all of a sudden, the blade is coming off the back of the lower wheel. If I adjust up upper wheel tracking to compensate, it's coming off the front of the upper wheel. I can't get the darn thing to stay on both wheels anymore. I'm very confused, as it was lined up, tracking correctly, and working wonderfully. Nothing appears to be loose.

Anything thoughts or suggestions would be greatly appreciated. I've got about 14' more to resaw for this project!

Thanks.

-Kevin

Re: Bandsaw problem

#2

Just speculating

Bill Houghton, Sebastopol, CA

>How clean is the blade? Did it get gummed up?

Re: Bandsaw problem

#3

JL

Re: Bandsaw problem

JL

>Of course my question is why are you using a 1 1/4" blade.

Like Bill, I would look at the front of the blade for gumming or deposits. After I checked the blade, I would check the wheels to make sure they are coplanar. While I was checking the wheels, I would inspect the tires.

Re: Bandsaw problem

#4

Re: Bandsaw problem

Ed Mulligan, Cape Cod

>Sounds like something is loose. Check again. Also, switch out the blade. If the new blade works, the problem is with the old blade. If the new blade doesn't work, the problem is in the machine.

Re: Bandsaw problem

#5

Re: Bandsaw problem

Kevin MacLuskie

>I bought the saw used about a year ago, and it came with 2 new 3/8" and the 1 1/4" blade. Yeah, I need to buy some others, but out of the ones I had, the larger seemed more appropriate for resawing. The blade seemed pretty clean still. I did wipe it down while inspecting it for any obvious flaws or damage.

Re: Bandsaw problem

#6

Re: Bandsaw problem

Kevin MacLuskie

>I checked the wheels and they do need some adjusting to be coplaner. But why would it work fine for a while, then all of a sudden start acting up. While I am going to fix the coplaner issue, I'm not convinced that's the culprit.

Re: Bandsaw problem

#7

Re: Bandsaw problem

jesse cloud

>I don't know the Jet, but not all hobbyist 18 inch saws can adequately tension a blade that big. Could be that as the blade warmed up, it stretched enough to cause the problem. Presume you have checked the thrust bearings. If one is too far forward, that can cause that type of trouble.

By the way, when I got my new bandsaw about a year ago, it was way out of coplanar and exhibited the same behavior.

Re: Bandsaw problem

#8

William Falberg

Re: Bandsaw problem

William Falberg

>Does your tensioning slide really slide, under tension?

Re: Bandsaw problem

#9

Re: Bandsaw problem

gary peterson

>everyone else said what I would check/do...process of elimination, don't talk yourself out of a potential remedy.