Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

noisy Unisaw

Posts

noisy Unisaw

#1

noisy Unisaw

Paul Blackwell

>About two years ago, my Unisaw got very noisy, a loud growly kind of sound. The forum said bad arbor shaft bearings, and as I remember, someone had written detailed step by step instructions on how to replace the bearings. I followed the directions faithfully and replaced the bearings, and all was well until a couple of weeks ago when the noise returned. There is no play in the arbor, and the cut is fine, just very noisy. Seems to me the bearings should have lasted longer than two years. I guess I'll have to bite the bullet and do it again. Does anyone have these directions or know how to access them from the archives? How about a bearing source other than the overpriced Delta parts? Any help greatly appreciated.

Re: noisy Unisaw

#2

Re: noisy Unisaw *LINK*

Brent Smith in Montreal

>Hi Paul,

Here's a link to the rebuild process. You can buy bearings at any bearing supply house. Definately cheaper, and probably a better quality. Here in Montreal, I use General Bearing. Just check the yellow pages for your area.


http://www.sawcenter.com/unisaw.htm

Re: noisy Unisaw

#3

All bearings are NOT equal

McKay

>I experienced noise in my newer powermatic band saw. I was surprised to learn that the stock bearings were of almost the poorest quality available. (They were not even sealed.)I replaced them with a much better quality bearing and have had no problem since. Good luck

Re: noisy Unisaw

#4

Jim Rahbe, Bedford Texas

Articles Section *LINK*

Jim Rahbe, Bedford Texas

>Paul,

Look in the upper left side of your screen and you'll find a link to the Articles section..

I've attached a link about bearing replacement on a JET, it should be about the same.

I agree with the others, I would take the old bearings to a local bearing supplier and have them matched for size with better quality bearings. My guess it will be less than half of what "factory" bearings cost.

Jim R.


Bearing Replacement

Re: noisy Unisaw

#5

see the Articles section

Bill Tindall

>I wrote an article on Unisaw replacement that is in the Articles Section. I got bearings from local bearing supply. A bearing can go bad at any time. You may just have bad luck.

Re: noisy Unisaw

#6

Re: noisy Unisaw

Pete in Holland, MI

>My Jet tablesaw bearings failed after about 5 years. Had always thought the arbor spun with kinda snugly. When I replaced the bearings, there was a means tightening up the shaft and pre-loading the bearings too much. As I put in the new bearings, I paid attention to that and now the saw coasts down over several seconds and is happy. Too much pre-load will damage any bearing.

Most machine builders use standard sized commoditiy bearings, thus you don't have to go back to the manufacturer to get expensive replacements. Look on-line or check out a local bearing supplier for better and often cheaper bearings next time.

Pete

Re: noisy Unisaw

#7

Jesper, Denmark

Re: And here is another one.

Jesper, Denmark

>http://www.woodcentral.com/bparticles/unisawbearings.shtml