Need Table saw advice.
Jim H
>I have a Ryobi 10 in Contractors Table Saw with the Folding- rolling Stand. I got it mainly due to the low footprint when not in use.
It has been ok for ripping stock, and small projects but it has two issues #1 No miter slot (it uses a funky built in sled that only travels about half the table length) so I can�t use a lot of the home made jig plans, Or feather-boards that depend on the slot.
#2 The insert is a thin metal piece on one side of the blade. The mounting tabs wont allow a thicker zero clearance insert.
Any advice besides scrap it and get a better saw?



