Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Bandsaw Kickback/Grab

Posts

Bandsaw Kickback/Grab

#1

Bandsaw Kickback/Grab

John M in Mid Mich

>Brand new 1" carbide "Resaw King" from Laguna on LT16 bandsaw. Test resaw cut on 5" wide white oak. When blade touches wood it grabs and sounds like a rifle shot. Tried slower feed, faster feed, same result. Never experienced this with my other carbide blade. Using pretty close to max tension, same as usual. What is wrong? Ideas?

John

Re: Bandsaw Kickback/Grab

#2

Re: Bandsaw Kickback/Grab

Torben Helshoj

>Dear John,

Blade tension should be pretty much at maximum of saw. From your post I cannot see that you are doing anything wrong. I would like to speak to you so please give me a call 800-234-1976. My name is Torben. It sounds like a faulty blade. What you describe could also be too aggressive hook angle on the blade, however Resaw King blades should all have a hook angle of 8 degrees. Steeper hook angles are used when you need faster feeding on softer woods, most often with mechanical feeding mechanism.

Please call and we ca see if we can solve your problem.

Torben

Laguna Tools

Re: Bandsaw Kickback/Grab

#3

Ellis Walentine

Thanks for checking in, Torben

Ellis Walentine

>I've seen your blades in action and I understand your concern. Thanks for addressing our visitors' concerns.

Ellis

Re: Bandsaw Kickback/Grab

#4

Re: Bandsaw Kickback/Grab

John M in Mid Mich

>Torben:

Thanks for response! I talked with Javier today, also. He said send the blades back for testing. I'm running at max tension on the LT16, so I don't think it is low tension. Can tension be too high? I just did a 7" wide resaw of some American Hornbeam (VERY hard stuff) and it went well, but the entry was not square, rather varied. The White Oak I cut earlier was perfectly square and the whole blade contacted at once. Is that the problem? It was a really scary event because I'm getting into the mode of doing lots more cuts on the bandsaw rather than the table saw because of the comfort/safety...I thought. Maybe I'll send you the block of oak, too.

John

Re: Bandsaw Kickback/Grab

#5

I think I would try

Keith Newton------WebKitFormBoundaryV6MZb+tiOpocz6

>tilting the top wheel back a little to put more pressure on the back of the blade against the thrust bearing.

If the hook on the front of the tooth is climbing away from the guides that might fix it, and would be easy to try before shipping it back.