Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Jet JWL 1236 Lathe Variable Speed Problem

Posts

Jet JWL 1236 Lathe Variable Speed Problem

#1

Jet JWL 1236 Lathe Variable Speed Problem

Ken Kisling

>My variable speed on my JWL 1236 Jet Lathe stopped functioning the other day. It appears that the drive belt only has tension on it on the lowest speed (550 rpm). When I move the variable speed handle to higher speeds the drive belt loses all tension. I can see that the wheel controlled by the variable speed handle does move towards the head stock when I move it to a higher speed but again there is no tension and the speed does Not increase. I believe this is a Reeves drive type of lathe. Thanks for any information.

Re: Jet JWL 1236 Lathe Variable Speed Problem

#2

Re: Jet JWL 1236 Lathe Variable Speed Problem

john lucas

>Ken Post it on the turning side and you will get more responses. It sounds like one side of the pulley is stuck. They way that drive works you manually change the spacing between one set of pulleys when you make the adustment. The belt then pushes the other pulley apart or if it needs to be a larger pulley there is a spring that pushed it closer together.

What usually happens is this sliding pulley stick and won't move. Ideally you need to remove it and clean and lube the shaft. That can be a challenge because the spring is pretty strong and you probably need some snap ring pliers. In a pinch you can try just spraying some thin lubrication oil in there. Don't use WD-40. It's not a lubricant and will just add to the problems when it dries up.

Re: Jet JWL 1236 Lathe Variable Speed Problem

#3

Re: Jet JWL 1236 Lathe Variable Speed Problem

George@Colonel's Workshop-Havertown PA

>Good Afternoon Ken,

John has it right! My 1236 Reeves unit is an awful pain when it doesn't work properly, and noisey all the time.. You will have to clean the shafts on which the pulley slides. Also, when you have it apart, its a good time to replace the drive belt. Yours may have stretched. By all means, get a pair of snap ring pliers, and prepare to deal with the spring. It'll come off the shaft fine! Getting it back on and anchoring it while engaging the snap ring retainer develops one's vocabulary and volume. I bought a pair of hose clamp pliers to compress the spring, while engaging the snap ring pliers to fit the retainer.

Next time I buy a lathe, it will have a simple stepped pulley which I can change manually without fuss.

George