Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

home made taper shims

Posts

home made taper shims

#1

home made taper shims

Tom Dunlap

>I know..shims are cheap at the borg...but I like getting the oink out of the pig and have my own.

The last time I made them I fabricated a jig that worked reasonably well. They came out being 5/16" x 6".

Does anyone have a link or description of theirs?

thanks

Tom

Re: home made taper shims

#2

Re: home made taper shims

Fred Davis

>Tom,

your shim size is nearly identical to what I make , except I used a 7" length for no particular reason.

I cut a board 3/4" thick by about six inches wide and a foot long and cut the profile of the shim into a edge and then running the jig between the fence and blade, I hold stock precut to seven inch length and every time I cut a shim off the stock , I reverse the stock end for end and cut again,, thereby keeping the stock sides parallel.

If that makes you uncomfortable running it that way , put a handle on the jig, though I never have and have cut shims by the thousands.

FredD

Re: home made taper shims

#3

Re: home made taper shims

Tom Dunlap

>You copied me! HAHAHA

Re: home made taper shims

#4

Re: home made taper shims

Fred Davis

>GMTA ;-))

Re: home made taper shims

#5

Jesper, Denmark

Re: home made taper shims

Jesper, Denmark

>A bundle of cedar shingles and yo have shims for the rest of your life.

Re: home made taper shims

#6

Re: home made taper shims

Fred Davis

>Depends on what you are using the shims for.

Shingles are great for door hanging and not worth anything for installing hardwood moulding like big Crown for instance.

FredD