Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Using Shortened Router Guide Bushings

Posts

Using Shortened Router Guide Bushings

#1

Using Shortened Router Guide Bushings

Mark Salomon

>I'd like to rout a mortise using the walls of a dado (1/8--3/16in. deep) as the guide for a shortened PC bushing. Put another way, I have a solid case with dados for the top/bottom and shelves. I'd like to route through mortises most of the way through the sides using the dado itself to guide a router equipped with a shortened guide bearing (I'll come from the outside afterwords with a flush trim bit to eliminate the possibility of blowing out the mortise. Of course I'll also include stops to limit the length of the mortises.) Does anybody see a problem with using a guide that is so short??

Re: Using Shortened Router Guide Bushings

#2

Shouldn't be a problem

doug f, san clemente, ca

>I've done it several times, especially with my Leigh dovetail jig. Stock bushings were too long so I just filed them down to about 1/4". I just had to be a bit more careful since there's not quite as much bearing surface to push up against a guide.

Doug

Re: Using Shortened Router Guide Bushings

#3

Re: Using Shortened Router Guide Bushings

Jim Dillon

>Mark,

Agree with Doug, should work just fine. I cut my guide down with a hack saw, then smoothed off the burrs etc. with a file.

Jim

Re: Using Shortened Router Guide Bushings

#4

Re: Using Shortened Router Guide Bushings

Barry Irby

>I cut two down recently for the Leigh Jig. Just held them lightly to a grinder and turned them round and round to them even. Worked fine.

Re: Using Shortened Router Guide Bushings

#5

Re: Worked Fine

Mark Salomon

>Tried it out and it worked fine. I used an upcut spiral bit and found that I could plunge all the way through without any tearout so that saves time. Thanks everybody.