Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Fixing a screw up.

Posts

Fixing a screw up.

#1

Fixing a screw up.

Virgil Johnson

>The first dadoe I cut on my tool chest was about 3/4" closer to the edge than it was supposed to be. I cut twice (both sides) and did not think once. I did not get upset but started thinking about ways to fix this. I came up with this idea.I milled a gusset from a piece of 3/8" x 1" brass and inlet into the cross piece flush to the front edge. Since this is a tool chest this should not look like a fix but rather design intent to brace the cross section.The drawers will cover the top and bottom. Regardless it is there whether it looks right or not.From this point on the feature is design intent :-)


img

Re: Fixing a screw up.

#2

Very clever

Bill Houghton, Sebastopol, CA

>

Re: Fixing a screw up.

#3

Re: Fixing a screw up.

Doug Ridley

>Nice fix!

Re: Fixing a screw up.

#4

The mark of a real craftsman...

Joe Pack

>Anybody can do it right the first time. It takes a true craftsman to cover up a screw-up and make it look like it was planned!

Merry Christmas from one true craftsman to another! :-))

Re: Fixing a screw up.

#5

really nice recovery

Bruce, a MN Galoot

>be sure to post a pic of the final toolbox. I'm always in the market for new ideas.

Bruce

Re: Fixing a screw up.

#6

Re: Fixing a screw up.

jesse cloud

>I hardly ever use decorative inlay. When you see it in something I did, there's a good chance its covering a screwup. Makes me feel about 2 feet tall when the customer thinks the inlay is the best part of the piece....

Good fix! Do post a pic when you are done!