Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Scroll Saw ?

Posts

Scroll Saw ?

#1

Scroll Saw ?

Ray - Middletown, IN

>I am about to cut a bunch of straight cuts parallel to an edge. What is the collective wisdom on setting a straight edge like a bandsaw or tablesaw. The bandsaw is not an option as the kerf is to wide and unfinished compared to a scroll cut. The first pass I made was with a small blade and the fence at an acute angle. Straight cut but not repeatable, to much wandering. I am guessing a wide blade (and who makes wide blades) and set to the drift.

Just obtained a new saw and in the process of setting it up, so don't have any experience with this saw yet.

Thanks,

Ray

Re: Scroll Saw ?

#2

Re: Scroll Saw ?

del schisler

>i own a hagner scroll saw and to cut a perfet streight line is going to be hard to do At least for me It wonder's quite a bit It will cut streight tho just feed slow Don't know what you are trying to do And how many You dont have a band saw You can get a 1/8" band saw blade for around $15 that will do a fine job With a fence it will do a good cut faster than a scroll saw and probly better my opinon

Re: Scroll Saw ?

#3

Re: Scroll Saw ?

Brian in Sandusky, OH

>A scroll saw will drift just like a bandsaw will.

Strike a line, and follow the line. Then set your fence to this drift.

The wider your blade, the better.

This is probably the best that you can do, but don't expect a scroll saw to really cut nice perfect straight lines like a tablesaw will.

Re: Scroll Saw ?

#4

ebd

Re: Scroll Saw ? *LINK*

ebd

>How thick is the material you are cutting? If it's 4/4 or less any decent bandsaw blade with a high number of teeth/inch and properly tensioned will give a very good straight cut. Also a decent fence like a Kreg is very helpful. The fence has to be really parallel to the blade.

If you are working with thicker stuff R&D Bandsaws have 1/8, 1/4, 3/8, 1/2, and 5/8 inch blade widths with 18 tpi. I included a link to them. Click on the link "Tough Tooth Bandsaw Blades" and then on "Two Wheel Flexible Back" and finally on "72" and Longer". At 0.025" kerf the difference between the bandsaw blade and a thin scrollsaw blade is 0.007". Hardly detectable. Were you talking about a tablesaw kerf?


R&D Bandsaws

Re: Scroll Saw ?

#5

Thanks guys

Ray - Middletown, IN

>I'm going to fight with the scroll saw for a bit for the cut quality difference. Bandsaw cuts just are not smooth enough and I don't want to sand the surfaces. I've got some experiments ready to try, I'll post any success stories.

Ray