Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

speednuts issue

Posts

speednuts issue

#1

speednuts issue

DizD

>I have a couple of frame clamps which use speed nuts on a threaded rod. Some of the nuts have started slipping when tightened and others seem to hold all the pressure I can apply with my fingers. I assumed the soft brass is wearing and causing them to jump threads. Is there any solution to this or is this just the nature of the beast?

Re: speednuts issue

#2

Re: speednuts issue

Howard Norman

>If they are brass speed nuts you should be able to buy replacements locally. The ones that I am familiar with are standard 1/4x20 which should be available at any decent hardware store.

Re: speednuts issue

#3

Re: speednuts issue *LINK*

John McGaw

>If your clamps are the type I suspect then these might be of use. And they will make tightening the clamp easier too. Probably worth a look anyway.


Quick-Release Knobs

Re: speednuts issue

#4

Re: speednuts issue

Bill Houghton, Sebastopol, CA

>If there's no visible damage on the rods, I think your hypothesis is probably correct - no solution other than buying replacements occurs to me.

If they're from Lee Valley, you might inquire about their warranty on these (heck, if they're from anywhere, you might inquire; but Lee Valley is more likely to respond).

1/4"-20 replacement nuts, in sets of four, are available from Lee Valley if your set is out of warranty.

Re: speednuts issue

#5

Re: speednuts issue

DizD

>Thanks - these look like speednuts inside a plastic knob so I'm not sure they would help with the slippage issue.

Re: speednuts issue

#6

Re: speednuts issue

DizD

>Hadn't thought about warranty, and you're probably right about LV responding (one is a LV clamp set). I think I'd rather just write em off as consumable item, like a spark plug on a car, rather than hassle about something that inexpensive.