Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

"Floor hinge" options

Posts

"Floor hinge" options

#1

JL

"Floor hinge" options

JL

>I've been working over at the playhouse supervising the rehabilitation of the rigging (new ropes and cable) and doing a lot of maintenance that has been deferred for too long.

Anyway - we discovered that we have a slot in the back of the stage that extends the entire width. It goes down to the basement level. It is for painting the back drops. You lower the drop down into the slot and slowly raise it as it is painted. It now has a new batten and a manual winch.

The boards which cover the slot are 1.5" thick pine and about 12" wide and 8' or so long. I want to hinge them to make sure that they don't fall down into the slot and are somewhat secure. They are currently held down with screws.

I was figuring on using standard butt/mortise hinges or something similar with the barrel of the hinge pointed up. I would cut a mortise in the slot board and the stage floor. We have a tempered hardboard skin on the stage floor, so the barrel of the hinge wouldn't really act as trip hazard.

Does anyone have a different idea? TIA

Re: "Floor hinge" options

#2

Lee Grindinger

It may not work

Lee Grindinger

>The flap will not open if the barrel is entirely below the surface of the stage, in fact, at least half the barrel has to stick above the stage for it to open 90 degrees. For a hinge to work it will have to be a compound hinge like a Soss or cup hinge and either of those options are probably more hassle than it's worth. It may be wise to stick with the original plan, boards screwed in place.

Re: "Floor hinge" options

#3

Ellis Walentine

Sosses would work

Ellis Walentine

>...if they're in the budget. I once made a 300 lbs. bathroom door for a well-heeled customer. Soss had hinges that took the load nicely. A bit of a pain to install on existing jambs, but that's another story.

So, yes, there are no serious loads on these hinges and Sosses should work. Other than that, the cheaper way out is to use butts and let the knuckle stick up half its thickness.

Ellis

Re: "Floor hinge" options

#4

Re: "Floor hinge" options

Bill Houghton, Sebastopol, CA

>If I understand you correctly, the boards are screwed down. That implies that the boards are wider than the slot - that there are battens or something on which they're resting.

If that's the case, why not use webbing, leather, or similar material to make hinges? It could be done in a way that would be flat to the stage - either mortised into the tops of the boards and the stage floor or butt hinge style with a little webbing sticking up to permit flopping over on the stage floor when open.

I'm picturing something like seat belt webbing. In fact, you could probably get enough webbing, in whatever color would hide well, from a junkyard for very little money - one belt should be enough.

Re: "Floor hinge" options

#5

JL

Too pricey.

JL

>

Re: "Floor hinge" options

#6

JL

Talked it over with the powers that be..

JL

>They like your suggestion. The boards aren't weight bearing. This would keep them in place.

I'm going to purchase webbing and use a heated nail to punch the holes. I'll then drive stainless steel screws through the holes into the floor.

Thanks for the idea.