Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

special straight edge

Posts

special straight edge

#1

special straight edge

eliot d------WebKitFormBoundaryAo1Kz+awUUYH8ShA

>Years ago, I saw a video of a method for getting three screws along the edge of a board to be perfectly co-linear -- i.e. to lie exactly on a straight line. I believe the method was intended to create a near perfect straight "edge" for checking a jointer table. This method purported to be much more accurate than even an expensive machined straight edge -- and it cost almost nothing. Does anyone remember this method? I think I remember how to do it, but my memory is not what it used to be.

Re: special straight edge

#2

Clint Searl

One method

Clint Searl

>Install the three screws with the middle screw noticeably lower than the outer screws. Pull a piece of monofiliment taut across the tops of the outer screws. Back out the middle screw to touch the monofiliment.

Clint

Re: special straight edge

#3

Re: special straight edge

Bob Burnet (NW FL)

>I believe there was an article in FWW several years ago that covered this very subject. It was in combination with an article on tuning up your jointer.

Bob

Re: special straight edge

#4

Re: special straight edge

Alan S

>John White's book "Care and repair of shop machines" describes in detail making and using these. He also wrote the fine woodworking article on the subject.

The key idea is that you need to make 3 bars, and check each against both of the others. If any pair of them matches without rocking on a high center screw, or allowing a feeler gauge between two low center screws, you know the heads are within .001" of being aligned. They won't keep that alignment over long term storage, so need to be set for each use.

Re: special straight edge

#5

Re: special straight edge

Thomas S Stockton

>I tried making these once and found it to be a pain. The problem I ran into was getting the screw heads to be perfectly parallel to the bar. I pre drilled the holes on the drill press and tried a couple of different times and just couldn't get it right. Oh well I just chalked it up to a personal problem and bought a long level that was pretty accurate.

Tom

Re: special straight edge

#6

aligning jointer blades

john lucas

>The way I learned to do this is to lay a piece of wood that's been planed flat across the blades. Put a pencil mark on the wood and one on the outfeed table. Align the two pencil marks. Rotate the blade and see how far the pencil mark moves. If it doesn't move raise the blade. Do this on both ends of the blade. When the pencil mark moves the same amount then the blade is parallel with the table. Then adjust the outfeed table or adjust the blade until the pencil mark does not move or just barely moves.

I usually use one of the magnetic blade setting jigs to get it close and then check it with the wooden straight edge. This has been as accurate as using my dial indicator gauge.

Re: special straight edge

#7

Rick L

Re: They are misinformed... *LINK*

Rick L

>A level is a better method than the screws on a stick. I have a 4' and 6' Starrett straight edge as I have been adjusting machines professionally. The screws in the board method is no where near the accuracy of a good or even mediocre straight edge.

http://home.comcast.net/~jaswensen/machines/straight_edge/straight_edge.html


Better inexpensive option