Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Adjuster for drum sander

Posts

Adjuster for drum sander

#1

Adjuster for drum sander

wayne

>Need some help I am building a drum sander and am about finished. The table will be adjustable and covered with sanding belt. Need some ideas on how to make the table adjustable to tighten the sanding belt. The belt is going to be driven by 1 1/2" PVC and a gear motor. I thought about cutting the side arms and installing wooden guides but don't know.


img

Re: Adjuster for drum sander

#2

Jack Screws

Dustmaker Mike

>is it to late to elongate the hole on the right hand side holding in the PVC? If not I would elongate them and put a few long screws though the rod holding the PVC and use them to adjust the tension.

Re: Adjuster for drum sander

#3

Re: Adjuster for drum sander

GalenV in Iowa

>Since it looks like you already have both rollers fixed you might try a slide plate under the bottom center of your table. Looks like you have room to make it have vertical adjustment for tensioning the belt.

Not sure if your rollers are already spaced for a standard belt length and how you insure it tracks though.

Nice project.

Galen

Re: Adjuster for drum sander

#4

since I am making it nothing is to late

wayne

>Just don't have any Idea of what you are saying any chance of a little drawing?

Re: Adjuster for drum sander

#5

Adjuster for drum sander that is the question

Wayne

>I figured I could take up any slack from underneath but the belt is custom made for size so I won't have but about 1/8" of slack but the tracking is what I am concerned about.

Re: Adjuster for drum sander

#6

Re: Adjuster for drum sander that is the question

Woodie49

>Why not use turnbuckels.

Re: Adjuster for drum sander

#7

Re: Cutting the side arms

GalenV in Iowa

>It doesn't look like you can cut the side member that supports your right roller. Not much room between the upright support and the bolts that look to hold the roller bearing. The bed also extends out to the roller. If you had room to make a cut and the stock was thick enough you could put dowel pins that are all thread with double nuts to allow you to tighten the belt and adjust one side or the other to track. A closer gap could be by using a tee nut set in one side and a jacking nut all with all thread.

A counter top tite joint fastener could also be used as the adjustment across the cut, along with plain guide pins.

If you have not set the final custom belt length maybe you could cut and extend the roller to give more room for adjustment.

Just kicking around ideas.