Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Polyurethane brush application

Posts

Polyurethane brush application

#1

Polyurethane brush application

DP

>Unfortunately I don't have the capability of being able to spray my finishes on my projects, yet. Therefore, I'm looking for some suggestions and or opinions on what kind of brush to use when applying urethane (not water base). I have a white China bristle brush, but seems to be a little too stiff. Thanks in advance.

Danny

Re: Polyurethane brush application

#2

That is what I use.......

Bill Tindall, E.TN

>Are you thinning it. It must be thinned for good brushing, about 1 part solvent to about 4 parts varnish. The foam "brushes" work well too.

Re: Polyurethane brush application

#3

Re: Polyurethane brush application

Chuck in ND

>Thats pretty much what I use are the cheap china brissle brushes, they sometimes come in a variety of sizes in a pack. If yours is a little stiff from being used, run a wire brush through the brissles a few times, that will soften them right up, unless trhe brush is too far gone.

Re: Polyurethane brush application

#4

Re: Polyurethane brush application

Dave Bair, Eaton Rapids, MI

>I cannot use a brush of any sort to get a good application of poly; I ALWAYS get bubbles. I have learned to thin the poly by 25-50% and apply it using a pad of cheese cloth. It takes at least four times as many coats as brushing but I'm pleased with the results.