Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Glue up question

Posts

Glue up question

#1

Glue up question

Barry Irby

>I made some end grained cutting boards. I glued up a bunch of strips and then sanded them flat in the Performax. There was 40 grit paper on the machine so I used it to clean up the surface. That left the surface rough with the parallel grooves characteristic of a drum sander. I changed the paper and sanded it to 120. Then I cross cut them, flipped the strip end to end and turned them ninety degrees to make it end grain and glued them again.

The question is, would it have worked just as well to glue the 40 grit surface? Would there be too much glue left in the joint? (Titebond III). Would the joints have looked open and poorly fitted? Is it time for an experiment?

Re: Glue up question

#2

Re: Glue up question

doug f, san clemente, ca

>Barry - I've been making a few of them for Christmas presents, too, and I just sanded to 80 grit and glued up from there. It works fine; no glue line and a nice tight joint. The important thing is to make sure your strips are flat and parallel.

Have fun with your project.

Doug

Re: Glue up question

#3

Re: Glue up question

paul in AZ------WebKitFormBoundary+isMX5X2paiDYC5e

>Agreed on the 80 grit.

Can't overemphasize the DEAD flat and parallel.