Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Warped Cutting board question???

Posts

Warped Cutting board question???

#1

Warped Cutting board question???

Barry Irby

>I have made an end grain cutting board as a Christmas gift. It was nice and flat when I made it several days ago. Now it teeters a bit when laid on a flat surface. I could support the high corners and sand it flat with the Performax, but should I bother? Don't care to make it thinner, but I could. Any suggestions. I am concerned its pointless as it might change again when the weather changes.

Re: Warped Cutting board question???

#2

Re: Warped Cutting board question???

Rob Stokes in N. Vancouver

>I made a few of these a couple of years ago and they moved a bit too. I suggested to the recipients that they turn them over and see what happened - they all flattened out again. Now that they've climatized to their various kitchens the reciepients turn them about once a week (ish) and they all stay flat (ish)

Re: Warped Cutting board question???

#3

Clint Searl

Firewood

Clint Searl

>

Re: Warped Cutting board question???

#4

Re: Warped Cutting board question???

chuckbeck in cent il

>When they are dry again and hopefully more flat, dado some runners in them, or rout some sliding dovetail rails in them. It will help to keep them up off of the counter when they are drying.

Re: Warped Cutting board question???

#5

Re: Warped Cutting board question???

Justin Szeliga

>My guess is that is has sat on one face, drying unevenly, for a few days. Try the suggestion of turning it over.

Re: Warped Cutting board question???

#6

Re: Warped Cutting board question???

Kneale Brownson..Back enjoying CO snow

>Get some toilet seat bumpers and use the smallest ones as legs.