Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Cordless Drill Woe

Posts

Cordless Drill Woe

#1

Cordless Drill Woe

Thomas Norton

>I have 2 older Makita cordless drills. I think they are 9.6V. After I charge the battery I get nothing when I put them in the drill. Yesterday I re-charged one of the batteries and then checked it with a meter. I had juice. But no go with the drill. Any thoughts??

Thanks

Re: Cordless Drill Woe

#2

Re: Cordless Drill Woe

Barry Irby

>I have several Makita tools (12 volt, drills and impact driver) I have found that crud or corrosion will get on the contacts for the battery and inside the handle. If I am on the job I take anything handy and scrap all the contacts. In the shop I polish them up with some really fine sand paper. I recently bent the clips/contacts inward on the impact driver. Very light touch here, just clean and shine them, don't sand them away.

Re: Cordless Drill Woe

#3

Re: Cordless Drill Woe

del schisler

>vinegar will clean off the green build up if that is the case Other wise use some 400 or higer grit and clean Than if you have some grease i would put a little on and wipe off That should do it Also their is a deoxIT cleaner that is the best and will clean and protect Some electronic supply houses has that It is the best you can get I use it here is the link You can check out and find a supplyer close by ??

http://store.caig.com/s.nl/sc.2/category.188/.f

Re: Cordless Drill Woe

#4

Re: Cordless Drill Woe

Bill Houghton, Sebastopol, CA

>The switches do go bad, but it seems unlikely both would go at the same time.

When they've gone bad on mine, there's a distinctly different mechanical feel to the switch.