Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Pin Nailers - I have a question

Posts

Pin Nailers - I have a question

#1

Pin Nailers - I have a question

rj in selby

>for those of you that use pin nailers. A few weeks back I bought a rigid pin nailer on sale at HD. I just got it out today to read the direction's. To adjust the depth you have to move the front plate which is held by allen screws. All my other nailers are PC and adjust with a wheel. It seems fidely to me. There is a difference in the size of pins they take, PC is up to an inch and Rigid up to 1 3\8. Don't know if you would use 1 3\8 with a pin nailer. The PC is on sale right now at Busy Bee Tools. I could return the Rigid. Any thoughts or advice would be appreciated.

Re: Pin Nailers - I have a question

#2

Re: Pin Nailers - I have a question

George@Colonel's Workshop-Havertown PA

>Good Afternoon RJ,

First, the pin nailers all take 23 guage pins, which referrs to the diasmeter of the fastener. Some take longer pins/longer fasteners. Pin nailers with the capability of shooting longer pins, say 1 3/8" or longer, will also shoot shorter pins in the 1/2" to 1.0" range. The adjustment feature you talked about may vary from one brand of nailer to another. No big deal, so long as it works well. Both models and brands you mentioned should work very well. I would be guided more by the length of the fastener actually needed (pinner capacity), than the depth adjustment feature. I almost never need to use a pin longer than one inch.

George

Re: Pin Nailers - I have a question

#3

Paul Kramer

Re: Pin Nailers - I have a question

Paul Kramer

>RJ

I have a Grex and adjust it with the air pressure for the various lengths. That's been working fine for me.

HTH,

Paul

Re: Pin Nailers - I have a question

#4

Re: Pin Nailers - I have a question

Fred Davis

>I have a Senco pin nailer which is probably the first company to make them and the striking force is adjusted by moving a Button to one of three postilions marked 1/2 - 3/4 and 1 inch.

Works like a charm , also I never confuse the limitations of a Pin fastener as opposed to a Brad and or a Finish nail.

FredD

Re: Pin Nailers - I have a question

#5

I have two

John Cotten

>I have a Harbor Frt. that takes up to 1" and a Grex that will take 2". The Grex gets the most use in my cabinet business. Great for moldings, If you locate the pins correctly, you don't even need to worry with filling them. We use it for installing crown and cove molding, base around the bottoms of the cabinets and other moldings as needed.

While the Grex is not cheap, nearly $300.00, it has been worth it. The Harbor Frt. has quit on me several times and had to have the O rings replaced. The grex has pinned several thousand pins, and the only thing I've had to replace is the rubber tip.

Re: Pin Nailers - I have a question

#6

Grex...the best!

Terry Alexander

>

Re: Pin Nailers - I have a question

#7

Re: Grex...the best!

rj in selby

>Thanks all for your comments. I have decided to keep the Rigid because of the lifetime warranty. I'll just adjust it for the 1 inch pins and leave it set. I have a PC brad nailer if I need more length.