Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

PC 333VS ROS Woes

Posts

PC 333VS ROS Woes

#1

PC 333VS ROS Woes

Terry Alexander

>All of a sudden....the hook and loop sanding disks will not stick to my PC333. Don't get me wrong....this sander has sanded miles of board feet....but it seems like "boom"....nothing will stick.

So, is there any "magic" to restoring the "stickiness" (is that a word?) or will I need to buy a new bottom plate thingy for it.

And of course....I am right in the middle of building our kitchen cabinets ;-(

As always...TIA

Terry Alexander in West Texas

Re: PC 333VS ROS Woes

#2

Yep…

Rod Peterson * Ormond Beach

>…that's pretty much the way it goes. There's good news and bad news. The good news is a new base has a 5/8 hole layout, meaning you can use either 5 hole (old) or 8 hole (new) paper with it. Also, as I recall, it's not horribly expensive and it's easy to change out. And, finally, my local tool repair shop had them in stock hanging on a display rack.

The bad news? Well, you're in the middle of a project…

By the way, "this sander has sanded miles of board feet" is the answer to the question, "how come my H&L pads don't stick anymore?

Rod

Re: PC 333VS ROS Woes

#3

Hooks always wear out...

John in NM

>After a few years anyway. One has to assume that the loops would wear out more quickly, and that's why they're on the sandpaper.

If you do a lot of sanding with just one grit, it may be worth switching to psa instead, but I change grits often enough that its worth buying a new pad now and then.

Re: PC 333VS ROS Woes

#4

Re: Yep�

Ken Oakley-Sunny St. Cloud,Fla

>Last time I was at Home Dept,long long ago, they also had the pads in stock.

Re: PC 333VS ROS Woes

#5

Ellis Walentine

Heat is the culprit

Ellis Walentine

>If your sander pad has lost its grip, it's probably because you applied too much pressure when sanding. The increased heat softens the plastic hook material and causes it to essentially melt and fail. Check it yourself with a magnifier.

Get a new pad. They're relatively inexpensive and well worth it.

Ellis

Re: PC 333VS ROS Woes

#6

Jason Roehl in Lafayette, IN

A less expensive option.

Jason Roehl in Lafayette, IN

>My local Lowe's carries (used to?) a kit for replacing the hooks. Basically, you sand off the bad hooks by gluing a piece of sandpaper (provided) to a flat surface and running the ROS over it sans looped sandpaper. Then you glue a new sheet of hooks on top of the old (glue and hook pad provided, of course). I found that the kit I used lasted much, much longer than the stock P-C hooks. Alas, now I need a new pad, though, as the pad itself has disintegrated.

Jason

Re: PC 333VS ROS Woes

#7

Re: Yep�

Glenn Madsen

>That's where I found mine, in the middle of a kitchen project. And they were 75% of the best web=based asking price I saw.

My sander works again! Can't imagine how spoiled I'd gotten using this one.