Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

sliding surface that locks out

Posts

sliding surface that locks out

#1

sliding surface that locks out

Simon St.Laurent - Dryden, NY

>I'm getting ready to build a changing table, to replace an old one that's just kind of collapsing.

I'd been planning to build a 4-drawer cabinet 24" deep with an edged top big enough to hold a changing cushion and still have some space in front to stand the child on when it gets older.

I have a somewhat tricky room with a narrow (19") door to deal with, though, so it has to be narrower. The old table has a hinged top that comes down to provide the extra space in front, but it's always seemed like an invitation to crushed fingers.

Instead of the hinged top, I was thinking of a flat surface, like the pull-out writing surfaces I've seen in some desks. They even seem to lock out, and with a bit of a lift unlock to go back in.

I can't find hardware that does that, though. I can think of a few ways to have something drop down from the bottom of the surface and lock it in place securely, but if there's something simpler, I'd love to know about it.

Re: sliding surface that locks out

#2

Drawer slides?

Bill Houghton, Sebastopol, CA

>Are there suitable drawer slides that you could use? I'd start with that.

Re: sliding surface that locks out

#3

almost, but locking open

Simon St.Laurent - Dryden, NY

>The piece I saw (a few years ago) looked like it had a drawer slide underneath, but the slide would lock at full extension.

If I can't find anything else, I'll go with a drawer slide and something that hinges down off the surface to lock it open.

Re: sliding surface that locks out

#4

think I found it

Simon St.Laurent - Dryden, NY

>Talking about "locking" triggered something, and these, from Lee Valley, are likely close enough to what I was thinking of to work.

Thanks!

Re: sliding surface that locks out

#5

Ellis Walentine

One other consideration...

Ellis Walentine

>... safety. From my days in the contract furniture industry, I know that we always designed filing cabinets with interlocks that prevented one drawer from being pulled out if another drawer was already extended. The idea was to prevent tipping of the whole cabinet and spillage of the contents. In your case, the contents could be the toddler standing on the extended surface. If you intend to proceed with this plan, I suggest providing some means of attaching the back of the changing table to the wall.

Ellis

Re: sliding surface that locks out

#6

I concur 100% with that Ellis.

Victor Parisian

>

Re: sliding surface that locks out

#7

Yep - definitely can attach it to the wall

Simon St.Laurent - Dryden, NY

>I'm less worried about the weight of a toddler tipping it than the weight of that child a few years later having too much fun.

Definitely worth preventing, though!

Thanks!