Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

So I made this cutting board

Posts

So I made this cutting board

#1

So I made this cutting board

Bob Entwisle in NJ

>Walnut with Cherry stripes, 7-1/2 x 18-3/4" x 3/4"

Claphams Beeswax Salad Bowl Finish.


img

Re: So I made this cutting board

#2

Jesper, Denmark

Re: So I made this cutting board

Jesper, Denmark

>Very nice.

Can you show a pic. of the routing set-up for the juice groove? I assume you made a jg? How did you locate the board in the jig?

Re: So I made this cutting board

#3

That's beautiful, Bob

David Barnett - SW FL Gulf Coast

>Both the wood and the design. Could kick me into another walnut phase.

Re: So I made this cutting board

#4

Re: So I made this cutting board

Fred Davis

>Really to nice to cut on Bob ;-))

FredD

Re: So I made this cutting board

#5

Re: So I made this cutting board - template

Bob Entwisle in NJ

>Jesper,

Basicly I just made a template out of 1/4" ply and double stick taped it to the board blank. I recently made some guitar parts and had fitted a template base to my trim router. I found I like the fine control that the small trim router gaves me, so I used the same base and router with a cut down template bushing and a 1/2" core box bit. here is a picture of the template:


img

Re: So I made this cutting board

#6

Re: So I made this cutting board - router

Bob Entwisle in NJ

>Here is a picture of the router base, template bushing, and bit.


img

Re: So I made this cutting board

#7

Re: That's beautiful, Bob

Bob Entwisle in NJ

>Thanks David.

If this kicks you into a walnut phase then my destruction of this piece of walnut is almost justified!

Re: So I made this cutting board

#8

Re: So I made this cutting board - thanks Fred

Bob Entwisle in NJ

>It's just another slice off my to-do list.

Re: So I made this cutting board

#9

Re: - locating template

Bob Entwisle in NJ

>Jesper,

On locating the template, I just placed the template onto the blank, and then measured a bit to locate it, I then put locating pencil marks on the template and blank. Then I pulled the template off, applied the double stick tape, and layed the template back down, lining up the pencil marks (and hoping I didn't go too far off them). I think the picture I posted has the 'tape side' of the template up (so I didn't get tape residue on the finished board), which is why you don't see the locating marks.

Don't take a vernier to it, but it seems to look ok.

Re: So I made this cutting board

#10

Jesper, Denmark

Re: - locating template

Jesper, Denmark

>Great, thanks. It is an inspiration.

Re: So I made this cutting board

#12

Re: So I made this cutting board

Chuck in ND

>Nice job Bob.