Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Gluing to finished surface?

Posts

Gluing to finished surface?

#1

Gluing to finished surface?

David Hay @ Denver

>I'm making a dollhouse for my daughter and I've been trying to finish the various components before assembly since it's easier at this point. I'm at the point where I need to start installing the interior walls. However, I've finished the floor and ceiling with poly and latex paint, respectively. Would a polyurethane glue work here? Some other type of glue? Or do I need to scrape away the finish where I want to glue the plywood to the floor ceiling? If it's the latter, any suggestions on how to do this?

Thanks!

David

Re: Gluing to finished surface?

#2

Bart Goldberg

Re: Gluing to finished surface?

Bart Goldberg

>I think it may depend on the type of glue. However, without knowing more, a finished surface will not hold as well as unfinished. You can try an experiment with some scraps first that are already finished and see how well your glue joint holds. I think that for your application, a really strong glue joint may not be needed. If this is the case, then it is probably would be ok to glue to the finished surface.

Bart

Re: Gluing to finished surface?

#3

Hot Melt Glue?

George@Colonel's Workshop-Havertown PA

>

Re: Gluing to finished surface?

#4

Re: Hot Melt Glue?

David Hay @ Denver

>I've not had very good luck with hot melt glue. I can't seem to get it applied without making a huge mess, and it seems like the open time is pretty short. Perhaps I'm using the wrong kind of glue?

Thanks!

David

Re: Gluing to finished surface?

#5

Ellis Walentine

Re: Hot Melt Glue?

Ellis Walentine

>Hot melt comes in many different ranges of adhesion and setup time, but I've only ever bought the glue sticks through industrial suppliers -- in 10" sticks, in boxes of 100 or more. I don't think any of the retail or mail order outfits offer much of a selection.

Ellis

Re: Gluing to finished surface?

#6

Re: Gluing to finished surface?

Fred Davis

>Put a few dots of Cyanoacrylate Glue along your glue line , put the part into it and hit it with a whiff of accelerator.

Very fast assembly that way and no worries about pre-finish.

FredD

Re: Gluing to finished surface?

#7

Re: Hot Melt Glue? McMaster *LINK*

Bob Entwisle in NJ

>McMaster-Carr has a pretty good selection and you can buy relatively small qty's

http://www.mcmaster.com/#hot-melt-glue-sticks/=4qj5x2

Scroll down the page, and/or take a look at the adjoining pages in the link


http://www.mcmaster.com/#hot-melt-glue-sticks/=4qj5x2

Re: Gluing to finished surface?

#8

Re: Gluing to finished surface? what Fred said!

Bob Entwisle in NJ

>

Re: Gluing to finished surface?

#9

Re: Gluing to finished surface? what Fred said!

David Hay @ Denver

>Thanks for the ideas. I'll probably try a combination of polyurethane glue and the superglue and see how that holds up. I may also put a few brads in it too, if I can figure out how to do that without blowing through the side of the 1/4" plywood.

David