Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

New toy and some questions

Posts

New toy and some questions

#1

New toy and some questions

Randy Johnson

>I bit the bullet yesterday and bought the last air compressor I will ever need. It exceeds any possible use I could ever come up with.

Until a few weeks ago my compressor (the vertical 30 gallon Dewalt that is sold everywhere) was used for two things; a brad driver, and blowing dust off of things. However, I�m now starting to move toward using more air tools and the DeWalt simply doesn�t have what it takes.

I pretty much know how to handle 95% of the plumbing but there are a few questions.

The compressor is a five HP two stage Ingersol Rand with an 80 gallon tank. The outlet and valve supplied with the compressor is half inch. I was planning on making the main run from the compressor � inch. (30X30 building) Will the current � restriction need to be replaced with � or will it be sufficient to �pack� the � at the start of the run?

My biggest question involves filters, regulators, and filter/lubricators.

In line with the question I have already asked, does the pipe on both sides of the filter/regulator/lubricator at the compressor need to be sized for the largest pipe or can it be reduced to half inch?

I know I will have to have regulators at all of the drops, but will I need to have a filter at each one or will the filter at the compressor take care of it?

For what it is worth, I think my biggest problem of all is how I�m going to get the compressor from the bed of my pickup to where it will sit in the shop. It is one of the disadvantages of getting older you seldom think about. Most of my friends are not in good enough condition to wrestle top heavy 400 pound compressors around. I will probably be borrowing my company's installation truck with the lift gate.

Re: New toy and some questions

#2

Clint Searl

Re: New toy and some questions

Clint Searl

>I have the same compressor for my 30 x 40 shop. No need to go 3/4. I left mine on the shipping pallet to raise it above the horse stall mat, to make draining easier. Isolate the main from the unit with a braided stainless connection. I initially put in a separater/regulator, but the shop has HVAC so the separater isn't needed. Place all the drops off a single run and use a hose to reach your work. I sweated 1/2 L copper, but if I were to do it now, I'd use the line and slip fittings from Kaeser Compressor. Incline the main line from beginning to end a couple inches and terminate with a petcock.

Clint


img

Re: New toy and some questions

#3

Clint Searl

Regulator 

Clint Searl

>


img

Re: New toy and some questions

#4

Clint Searl

Drop 

Clint Searl

>


img

Re: New toy and some questions

#5

Re: New toy and some questions

Michael Wilkins

>The latest issue of Woodcraft Magazine has an article on compressed air, types, fitting, etc. Also Fine Woodworking has an article in one of the past Tools and Shops issues on compressed air set-ups. Both are worth a look and read.