Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Delta bandsaw table slippage

Posts

Delta bandsaw table slippage

#1

Delta bandsaw table slippage

Don in STL

>I have an almost six-year old Delta 26-208 bandsaw that has only been used five or six times. Recently I decided it was time to set it up properly and get some use out of it. In the process I bent over to pick up something off the floor and leaned on the table to support myself. The table pivoted down, as though it was loose. When I attempted to push it back level it became obvious that it was no longer connected to the base of the saw. The front and back trunnions had crumbled into little pieces.

I contacted Delta, who kindly sent me replacements. They said that the trunnions are made of zinc and the castings are thin, being only .050 inch thick.

I have remounted the table, but I find that just like with the original trunnions the table must be turned down really tight to keep it from slipping. I suspect that this is why the original trunnions failed.

Has anyone else experienced a similar problem and if so, did you find a way to resolve the table slippage problem without having to over tighten the adjustment?

Thanks for your help.

Re: Delta bandsaw table slippage

#2

Don't have this type of saw

Bill Houghton, Sebastopol, CA

>but I've been very impressed lately by the spring, or wavy, washers of the type that Lee Valley has started using in their tools. For some reason, these are commonly available around here only in metric sizes, but you can often find a suitable size to match to a fractional bolt. They put pressure on the components in a very controlled and controllable way.

Re: Delta bandsaw table slippage

#3

Re: Delta bandsaw table slippage

del schisler

>i have a 14" floor Model 28-245 with rizer My table has cast iron trunnions. Mine will not slip with just hand tighten Maybe your's is not all their Do you have a manual? I cant find your's listed in google search Here is a nice link for parts tho

http://www.sawcenter.com/bandsaw_parts.htm

Re: Delta bandsaw table slippage

#4

Re: Delta bandsaw table slippage

Don in STL

>You got me Del. It's a Delta 28-206.

Are you positive your trunnions are cast iron? I checked mine with a magnet. That's what prompted me to inquire from Delta when I ordered new ones.

By the way. I initially inquired at a local DELTA|PORTER-CABLE/DEWALT factory service center and they thought the trunnions were cast iron.

I looked your saw up on Delta's web site and item 122 (the back trunnion) sells for $6.52 and item 126 (the front trunnion) sells for $10.97, including the gauge, which comes attached. That just sounds cheap to me for cast iron. My zinc trunnions run about the same price.

You have touched on a point I am curious about. Do all Delta band saws have zinc trunnions or do they very?

Re: Delta bandsaw table slippage

#5

Re: Delta bandsaw table slippage

Bill Earl

>I have an older one (about 1985-6). It claimed to have cast-iron trunnions at the time and they do check out with a magnet.

Re: Delta bandsaw table slippage

#6

Re: Delta bandsaw table slippage

Don in STL

>Bill, would you mind giving me the model number of your saw? I would like to check it out further. If I can find cast iron trunnions that will fit, I'll be happy.

Thanks,

Don

Re: Delta bandsaw table slippage

#7

Re: Delta bandsaw table slippage

Bill Earl

>It is a 28-243X.