Help Cutting Compound Angles
Mark Meier (Ann Arbor, MI)
>I'm building some stands to roll around the studio while sculpting (clay). Here's the design. There are three legs which taper outward from top to bottom.
I've built the easy stuff... thanks to Ed Mulligan's response to this post: Easy Way of Cutting a Perfect Hexagon?. Thanks, Ed!
Now I need to make the bases. In a pure side view the leg is at an angle of 12 degrees from vertical.
The rails join the legs to form triangles in plan. So the angles on the ends of the rails are 30 degrees. However I think that's affected by the outward taper of the legs. But this is what I'm unsure about.
I've never cut compound angles before so I'm not sure if I can really use 12 and 30 degrees or if they combine in some way that changes them. Does anyone have a recommendation for a method of calculating and cutting these accurately?
I can use either the table saw or a sliding compound mitre saw.
Thanks in advance for any help!
Mark








