Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Loft ladder revisited

Posts

Loft ladder revisited

#1

Loft ladder revisited

Ray Carson - Lawrenceville, NJ

>Against some of the best advice I've ever received here on WC, I decided to accept this project. Reason....it posed a challenge. I like challenges that make me think. Always trying to build my skills.

To refresh, see

Subject: Loft ladder advice needed.

Posted By:Ray Carson - Lawrenceville, NJ

Date: Monday, 19 October 2009, at 3:52 p.m.

Well, the project is under way and I've hit my first challenge. How do I make this joint? I'm referring to the dado needed for each step. the stringers are tapered. Again, see previous post. The stringer is too long to nibble away on a table saw. The dados in the middle would be easy, but once I have 8 plus feet hanging off the side of the table saw, it's gonna get tricky. To do this I would have to tilt the balde and the miter gauge. I'm thinking of a jig using a router that would slide across the stringer. However, the router needs to be tilted. I think I can incorporate a wedge into the jig to tilt the router.

What do my fellow woodworkers think? (and don't say you should never have accepted the work) LOL :-)

Thank you,

Ray


img

Re: Loft ladder revisited

#2

Norm did this…

Rod Peterson * Ormond Beach

>I vaguely remember the compound issues, but I don't recall the technique he used. Episode 9804, Library Ladder, if you want to look around. I don't think I have time to review it myself, as I have a deadline project going on prior to our Thanksgiving trip to ATL with the kids & Mom.

Rod

Re: Loft ladder revisited

#3

Dale Lenz

I'm thinking...

Dale Lenz

>cut your dados flat with a router then cut your step ends at the appropriate angle. I'm thinking it should work???

Re: Loft ladder revisited

#4

Re: Loft ladder revisited

mdclor

>Try a radial arm saw with a dado cutter head.......at least, I think that is the way Norm did it. I could be wrong due to advancing Alzheimer's! :)

HTH,

Merle

Re: Loft ladder revisited

#5

Jim DeLaney, Austintown, Ohio

Re: Loft ladder revisited

Jim DeLaney, Austintown, Ohio

>I'd make a tapered base for a router. Make the tapered base rectangular, not tound, and then use a guide board or clamp to ensure that the dado gets cut at the proper angle.

Jim D.

Re: Loft ladder revisited

#6

Re: Loft ladder with hand tools

Glenn Madsen

>You're making one, right? Why not cut these by hand with a joinery saw? Can't be too terribly tough, and you'd be done before you'd have the jigs built...

Re: Loft ladder revisited

#7

I think Glenn is right

Bruce, a MN Galoot

>all it takes is a sliding bevel gauge, a saw, and a chisel.

Re: Loft ladder revisited

#8

Re: Loft ladder - Thanks everyone.

Ray Carson - Lawrenceville, NJ

>Some good advice, again, from all my WC peeps. Sounds like I'm on the right track. I'll keep you all posted.

Ray

Re: Loft ladder revisited

#9

Re: I think Glenn is right

Kneale Brownson..Back enjoying CO snow

>I'm not much of a hand tool guy, but this is an example of where I think handwork applies.