Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Installing Prefinished Hardwood Stair Treads...

Posts

Installing Prefinished Hardwood Stair Treads...

#1

Brian McKearney

Installing Prefinished Hardwood Stair Treads...

Brian McKearney

>I usually hang out on the Turning side, but thought that I'd ask this question here - hoping someone can clear up my confusion.

I've done quite a bit of woodworking - both turning and plenty of furniture projects, so I think that I can handle installing stair treads.

I've done a bit of research on the topic and I would prefer to purchase and install prefinished hardwood stair treads on my stairway for simplicity after the installation is complete - finishing isn't going to be trivial with the family around.

I'm pretty confused how folks actually install prefinished stair treads. From everything that I've read, it sounds like the most recommended approach is to glue the treads down, AND secure each tread with screws. Here's my confusion - if I screw a prefinished tread, then I have a screw hole that has to be filled and finished and this sounds like a real pain on a prefinished piece of wood.

Anyone have any experience that they can share? Do folks recommend just gluing and no screws? What about squeaks with no screws? Am I missing something, or is it the best approach to just install unfinished treads and work through the finishing later?

Any advice? Any good links that I should check out before I start this project?

Brian

Re: Installing Prefinished Hardwood Stair Treads...

#2

Re: Installing Prefinished Hardwood Stair Treads..

Fred Davis

>If these are "housed Treads" them it's simply a matter of wedging from the bottom side of the tread.

If the stringers are notched then the screws would be installed underneath the tread at angle into the stringer and also through the riser into the back edge of the tread..

For the glue I would use a construction adhesive like PL400 or 500.

FredD

Re: Installing Prefinished Hardwood Stair Treads...

#3

a carpenter's recommendation

Bill Tindall, E.TN

>Following is what my brother does and it has worked for me as well.

Apply construction adhesive and then nail with #16 finish nails(three per tread), or I suppose you could use "finish" headed screws. Fill the small holes with colored putty.

Re: Installing Prefinished Hardwood Stair Treads...

#4

Re: Installing Prefinished Hardwood Stair Treads..

Fred Davis

>Brian,

a couple of thoughts I didn't take the time to run by you the first time.

You didn't say whether this staircase had handrails with Balusters or not. But if it does , you can locate the Baluster placement and install a screw under the Baluster before the Baluster goes in.

Stair companies I have used over the years as a Contractor and stairs I have built myself do not use nails as fasteners when screws are so much better.

In the event you do nail it down , use a Case nail rather then a finish nail because of the larger head and it's configuration for increased withdrawal resistance.

Assuming your going to buy a standard Oak tread 1 1/8th thick with a bullnose for a one inch overhang , then try to get some trim head finish screws if you attach from the top. The trim head screw is very little larger then a Case nail and you can either prebore and plug it or fill with colored wax , either way is not as neat as attachment from underneath.

Member of Brotherhood of Carpenters and Joiners since 1959.

FredD