Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Ceramic Bandsaw Thrust Bearings

Posts

Ceramic Bandsaw Thrust Bearings

#1

Ceramic Bandsaw Thrust Bearings

George@Colonel's Workshop-Havertown PA

>Good Morning Friends,

Has anybody used these and are they any good? I just replaced my top conventional ball thrust bearing in my 14" Jet Bandsaw after a few months use, and need to buy a couple spares in advance. Klingspor says the ceramic ones will last longer. Experience? Thanks.

George

Re: Ceramic Bandsaw Thrust Bearings

#2

Re: Ceramic Bandsaw Thrust Bearings

Mark Mandell - Gone Round In Jersey

>Morning George,

I tried several set-ups on my JET 18" (stock, ceramic, cool, etc.) but finally went for the Carters. Couldn't be happier! Quiet, Very Accurate even with smaller blades (although a bit fussy to set with blades under 3/8").

Re: Ceramic Bandsaw Thrust Bearings

#3

Jim DeLaney, Austintown, Ohio

Re: Ceramic Bandsaw Thrust Bearings

Jim DeLaney, Austintown, Ohio

>Well... Ceramic came 'standard' on my Laguna 16, and after getting used to having the occasional spark (normal, and not a problem says Laguna...), I liked it so well that I bought a set for my TaiChi 14" saw a couple years ago. They've worked fine. No fuss, and they should outlast several bearings. YMMV

Jim D.

Re: Ceramic Bandsaw Thrust Bearings

#4

Re: Ceramic Bandsaw Thrust Bearings

Cecil Nickerson

>Had them on my Laguna LT 24. They cost me two $500.00 carbide resaw blades. I was going to go with a proven design (Carter) before I sold the saw. If your blade dulls so that you are making sparks you will find heat cracks on the back. In my opinion the risk of having a red hot (literally) spot on the ceramic disk touching the blade during heavy going is a big no-no.

Cecil, who never misses a chance to give an opinion on any thing at any time :)

Re: Ceramic Bandsaw Thrust Bearings

#5

Jim DeLaney, Austintown, Ohio

Re: Ceramic Bandsaw Thrust Bearings

Jim DeLaney, Austintown, Ohio

>Just curious

How could a brief sparking on the back edge destroy a blade? If the blade is set up right, it'll only contact the ceramic when a lot of pressure - like from too fast an attempted feed speed - is applied to the front (teeth) of the blade.

How did you blades break? At the weld? After how long a use?

Could they have been re-welded and put back in service?

It's hard to believe that a 180" blade band gets hot enough to affect the steel's temper. It's a spot heat, which will then have a whole revolution of cooling before seeing the ceramic again. Did the hot blade melt the tires? It'd be contacting the tires for a lot longer than it's be touching the ceramic.

If you mean the ceramic side guides, then they were likely adjusted too tight.

I've run an awful lot of wood through my Laguna - with no blade life problems at all.

Jim D.