Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

OT Concrete Grinding

Posts

OT Concrete Grinding

#1

OT Concrete Grinding

Mark Mandell - Gone Round In Jersey

>I'm about to rent a grinder to level and smooth my garage floor. This needs to be done in order to get my air suspension system to move my lathe around as the surface is presently too rough for the casters to work properly.

Has anyone here run one of these grinders (6 diamond "stones"), and if so, any tips?

Thanks

Re: OT Concrete Grinding

#2

Re: OT Concrete Grinding

Pete in Holland, MI

>A) Dust is a big problem, even with a wet system. Protect anything with bearings. Blow/vaccum the entire building afterwards, else this abraisive dust will be falling down for years to come.

B) Have you thought about bigger wheels instead?

c) Be carefull about making it too flaw free. You may affect the topography more than you planned on and have a rolly-polly surface to deal with.

Pete

Re: OT Concrete Grinding

#3

Wet/Wheels

Mark Mandell - Gone Round In Jersey

>I'll be doing this wet, for sure, but wheels are not a factor as the lathe will move on air casters (think hovercraft). I'll only be knocking down the peaks and bumps left by the broom finish so I can seal the floor and get a good surface for the "curtains".

Re: OT Concrete Grinding

#4

Re: OT Concrete Grinding

Bill Houghton, Sebastopol, CA

>Have you considered one of those epoxy garage floor finishes instead - smoothing by covering instead of removing?

Re: OT Concrete Grinding

#5

Epoxy

Mark Mandell - Gone Round In Jersey

>Hi Bill, Yes I have. My problem, however, is raised bumps and ridges. The epoxy's great for pits and stuff, but I have to get the surface fairly level first. Then there are the issues of nearly $900 for the materials and the cold weather (long cure) to deal with. I only need to do a strip about 4' wide by 20' long, so the grinder and then a clear sealer seem to be the way to go.

mm

Re: OT Concrete Grinding

#6

Flaw-Free

Mark Mandell - Gone Round In Jersey

>Basically, it has to allow a suction cup to stick, so there can't be much variation. I'm just trying to get an area of about a car leveled, but I'll have water running and the door open.

Rental guy said it shouldn't take me more than 2 hours, but then, he's a "Rental Guy" who practices that blank look when you bring the thing back hours late.

Re: OT Concrete Grinding

#7

Re: OT Concrete Grinding

Barry Irby

>Mark, I rented a grinder years ago that had carborundum stones on it, thinking I could convert my floor to exposed aggregate. Hours later, not much improvement. Never tried the diamond version. Hope yours is faster/better than mine. Never again for me.

Re: OT Concrete Grinding

#8

Re: OT Concrete Grinding

Doug Ring

>Have you talked to any floor installers about hiring this job out instead? Here in SoCal, almost all of the houses are build on slab, so if you are laying hardwood on the ground floor you will undoubtedly have to do some grinding and filling. After my first attempt at grinding, I threw in the towel and hired a prep guy - money very well spent. His blower/vac remains outside the house, and even though he dry-ground the surface, there was literally no dust left over.